Samsung CT-20D9BW, CT-21S7W Connecting a VCR, Unplug the cable or antenna from the back of the TV

Page 15

I N S T A L L AT I O N

Connecting a VCR

These instructions assume that you have already connected your TV to an antenna or a cable TV system (according to the instructions on pages 2.1-2.4). Skip step 1 if you have not yet connected to an antenna or a cable system.

1

Unplug the cable or antenna from the back of the TV.

2

Connect the cable or antenna to the ANTENNA IN terminal on the back of the VCR.

3

Connect a coaxial cable between the ANTENNA OUT terminal on the VCR and the antenna terminal on the TV.

A coaxial cable is usually included with a VCR. (If not, check your local electronics store).

4

Connect a set of audio cables between the AUDIO OUT jacks on the VCR and the AUDIO jacks on the TV.

5

Connect a video cable between the VIDEO OUT jack on the VCR and the VIDEO jack on the TV.

Follow the instructions in “Viewing a VCR or Camcorder Tape” to view your VCR tape.

Note:

•If only one jack (Audio L or R jack) is connected, sound is output from only one speaker.

•If the Audio L/R jacks are connected but the Video jack is not connected, no sound is out- put.

•When connecting a mono equipment, if the front is connected to Audio L, the back must be also connected to Audio L. (If differently connected, malfunction may happen.)

CHAPTER TWO: INSTALLATION 2.5

Image 15

Contents CT-1488BL/CT-1488L/CT-14S7BL AA68-02343A-00 ENGRisk of Electric Shock Do not Open Thank You for Choosing Samsung Example Antenna Grounding Installation Your New TVOperation Troubleshooting Special FeaturesChapter One List of FeaturesFamiliarizing Yourself with The TV Rear Panel Jacks Video and Audio input jacks´ VHF/UHF Antenna terminal MTS Option Remote Control´ Number buttons +100Antennas with 300-ohm Flat Twin Leads Connecting VHF and UHF AntennasCable without a Cable Box Connecting Cable TVAntennas with 75-ohm Round Leads Separate VHF and UHF AntennasConnecting to a Cable Box that Descrambles All Channels Connecting to a Cable Box that Descrambles Some ChannelsConnect this cable to a two-way splitter Install AT I O N Unplug the cable or antenna from the back of the TV Connecting a VCRConnecting a Camcorder Installing Batteries in the Remote Control Viewing the Menus Press the Power button on the remote controlTurning the TV On and Off Viewing the Menus and On-Screen DisplaysSelecting a Menu Language Selecting the Video Signal-source Memorizing the ChannelsANT antenna STD, HRC or IRC all cable TV Storing Channels in Memory Automatic Method Press the VOL+ or VOL- button to select Added or Erased Adding and Erasing Channels Manual MethodChanging Channels Adjusting the VolumeOr CH button repeat Edly until the correct hour appears Setting the ClockPress the Menu button to display the menu Customizing the PictureUsing Automatic Picture Settings Using Automatic Sound Settings Viewing a VCR or Camcorder Tape Press the VOL+ or VOL- buttonPress the Menu button twice to exit Chapter Four Fine Tuning ChannelsChanging the Screen Size Using the Surf Feature Setting the On/Off Timer Setting the Sleep Timer When finished, press VOL + buttonPress the Sleep button on the remote control Choosing a Multi-Channel Sound MTS Soundtrack Option Sound FeaturesSurround Extra sound settings Turbo Sound, or SurroundViewing Closed Captions Chapter Five Identifying ProblemsCleaning and Maintaining Your TV Using Your TV in Another CountrySpecifications