Samsung DVD-R125 Connecting HDMI/DVI to a, Case 2 Connecting to a TV, With DVI Jack

Page 21

Connecting HDMI/DVI to a

TV

If your TV has a HDMI/DVI input, connect HDMI/DVI Adapter cable to a TV. You will enjoy the best quality images and sounds.

● Case 1 : Connecting to a TV with HDMI Jack

red

white

Connecting

●Case 2 : Connecting to a TV with DVI Jack

Case 1 : Connecting to a TV with HDMI Jack

• Using the HDMI cable connect the HDMI OUT

white

red

& Setting Up

jack on the rear of the DVD Recorder to the HDMI IN jack of your TV.

• Press the input selector on your TV remote control until the HDMI signal from the DVD Recorder appears

on your TV screen.

To change HDMI output resolution, see page 36.

NOTE

HDMI (High Definition Multimedia

Interface)

HDMI is an interface to enable the digital transmission of video and audio data with just a single connector. Since HDMI is based on DVI, it is completely compatible with DVI. The only difference between HDMI and DVI is that HDMI supports multi-channel audio.

Using HDMI, the DVD recorder transmits a digital video and audio signal and displays a vivid picture on a TV having an HDMI input jack.

HDMI connection description

HDMI connector - Both uncompressed video data and digital audio data (LPCM or Bit Stream data).

Case 2 : Connecting to a TV

- Though the DVD recorder uses a HDMI

cable, the DVD recorder outputs only a

with DVI Jack

pure digital signal to the TV.

•Using the DVI Adapter Cable, connect the HDMI OUT jack on the rear of the DVD Recorder to the DVI IN jack of your TV.

•Using the audio cables, connect the AUDIO (red and white) OUT jacks on the rear of the DVD Recorder to the AUDIO (red and white) IN jacks of your TV. Turn on the DVD recorder and TV.

•Press the input selector on your TV remote control until the DVI signal from the DVD Recorder appears on your TV screen.

■ To watch through the HDMI output, set the digital audio output to PCM.

CAUTION

See page 32~33.

 

■Depending on the HDMI device (TV/HDMI Receiver) you use, audio may not be supported. If TV does not support Dolby digital/DTS, Audio output is not available when you set Digital output as Bitstream or select DTS On in Audio setup menu. In this case, set the digital audio output to PCM or DTS off.

- If TV does not support HDCP (High- bandwidth Digital Content Protection), snow noise appears on the screen.

Why does Samsung use HDMI? Analog TVs require an analog video/audio signal. However, when playing a DVD, the data transmitted to a TV is digital. Therefore either a digital-to-analog converter (in the DVD Recorder) or an analog-to-digital converter (in the TV) is required. During this conversion, the picture quality is degraded due to noise and signal loss. HDMI technology is superior because it requires no D/A conversion and is a pure digital signal from the DVD recorder to your TV.

What is the HDCP?

HDCP (High-bandwidth Digital Content Protection) is a system for protecting DVD content outputted via HDMI from being copied. It provides a secure digital link between a video source (PC, DVD. etc) and a display device (TV, projector. etc). Content is encrypted at the source device to prevent unauthorized copies from being made.

English -21

Page 20 Page 22
Image 21
Page 20 Page 22
Contents DVD-R1250/R121 No rights are granted for commercial use EnglishImportant Safety Instructions PrecautionMaintenance of Cabinet Handling CautionsUsing MPEG4 disc Using CD-R/RWDVD-RAM Disc Playback and Recording Contents Before Recording Troubleshooting SpecificationsBefore Playing Playing a DiscGeneral Features Before reading the user’s When using a DVD-R disc When using a DVD-RW disc in Video ModePreparing the Remote Control AccessoriesSetting the Remote Control UnpackingControllable TV Codes Description Front PanelFront Panel Display From aerial connector Out to TV connector AV1TV Output Scart Connector AV2EXT Input Scart ConnectorRear Panel FanTour of the Remote Control Quick Overview Quick OverviewAdditional connections Video output cableDVD mode Connecting the DVDTV mode RecorderVideo, Component video and Progressive Output Modes Other type of connecting the Video output cableCase 2 Connecting to an S-Video output jack Case 3 Component Video output jacksSee pages 34~35 If your TV has audio input jacks, use this connection Case 1 Connecting to your TVConnecting HDMI/DVI to a Case 2 Connecting to a TVWith DVI Jack Case 2 Connecting a DV Device to the DV in jack Connecting to AV3 IN, DV input jackIf the input is not selected automatically Use Input button to select proper inputOn-Screen Menu Navigation Auto Setup function… † , œ √ Buttons OK ButtonPlug & Auto Set up Press the …† buttons to select On for the Auto Clock Setting the ClockPress the OK button, then the date and time will be saved You must have the RF cable connected toChannel scan will be started Press the OK button to stop the Auto SetupPresetting Channels with the Manual Setup function Setting up the Language Options Language setup menu will be displayedTo the previous menu System menu will be displayed EP Mode Time SettingCreation Automatic ChapterThen press the OK or √ button Press the œ √ buttons to select Yes and press the OK buttonWith the unit in Stop mode/No Disc mode Setting up the FrontDisplay Options Press the Menu buttonAudio setup menu will be displayed DivXR Registration Setting up the Audio OptionsAudio Options Setting up Video Output OptionsDigital Output Dynamic CompressionSetting up the Progressive scan Message Video Output Mode Interlace Scan will appear Canceling the Progressive scanDisplayVideo Options To the previous menu. Press the Menu button to exit the menu If you forgot your passwordPress the …† buttons to select Change Password About the Change PasswordAbout the Rating Level Press the …† buttons to select Rating LevelBefore Recording Recordable discsCompatibility between Samsung and Other Company’s Recorder Concerning Copy Control Signals Recording ModeRecording Formats Unrecordable videoWatching Programme you areAbout Info Key Press the OPEN/CLOSE button to close the disc trayPress the REC button SP LP EP XPTo stop recording Icon is displayed on the front panelTo pause recording Recording from external equipment you are watchingPR Number AV1 AV2 AV3 DV Front panel display changes in the following sequencePress the Input button to select DV Copying from a CamcorderPress the REC button to start recording Making a One Touch Recording OTR030 100 .. Off TV Programme 1 toWith the unit in Stop mode, press the Timer button Making a Timer RecordingUsing the Menu button Set timer recording optionFlexible Recording For Timer recording only If the timer settings overlapPress the OK button Selected entry will be deleted from the list Deleting the Scheduled Record ListUsing the Video Plus+ Feature Timer List Video Plus+ ExtendedWith the unit in Stop mode, press the Menu button Playback Playing a Disc Press the Stop button to stop playbackPress the OPEN/CLOSE button Searching through a Chapter or Track Using the Search FunctionsPress the Title List button to move to the Title List During play, press the SearchAbout Anykey Moving to a scene directly using the AnykeySlow Motion Play Step Motion PlayPlaying RepeatedlyRepeat Playback Using the Repeat FunctionPress the …† buttons to select Time Press the Repeat button during playbackRepeat is highlighted Press the Repeat button repeatedly to select OffSelecting the Subtitle Press the Subtitle button during playbackRepeat playback of the A-B section starts Changing the Camera Angle Selecting the Audio languagePress the Audio button during playback Desired audio languageUsing Bookmarks Zooming-InNormal size 2X 4X Press the Cancel button to delete the selected bookmark Using MarkersPlaying back a bookmark Clearing a bookmarkPlaying an Audio CD CD-DA/MP3 Playing an Audio CD/MP3Press the / button Fast Play X2, X4 Insert an MP3 Disc into the disc trayAppears in a defined order MP3 Screen ElementsFiles of multiple types Topmost GUI Menu screen Disc NavigationPlay Option Mode To Programme Tracks Press the œ √ buttons to select Play OptionPress the Play button to playback the playlist English Slide show screen will appear Playing a PictureInsert a Jpeg into the disc tray Press the …† œ √ buttons to select a picturePlaying an MPEG4 When MPEG4 file is played, you can use following functionsInsert an MPEG4 Disc into the disc tray MPEG4 Function DescriptionPlay, Rename, Delete, Edit, Protection See pages 70~73 Playing the Title ListPress the Menu button Edit menu is displayed on the rightPress the …† buttons to select Title Title List Screen ElementsDisc Manager Title ListPlay List Basic Editing Title List Using the Menu buttonRenamingLabeling a Title Press the Menu buttonDeleting a Title LockingProtecting a TitleDeleting a Section of a Title Press œ √ buttons to select Yes, then press the OK button Press the OK button to select the DeleteEdit Title List Screen Elements Playback related buttonsPress the OK button at the end point Creating a PlaylistPress the OK button at the start point To make a new playlistPlaying Entries in the Playlist Playlist entries will be played VR modeWith the unit in Stop mode, press the Play List button Follow these instructions to play the playlist entriesEnter the desired characters using the …† √ buttons Renaming a Playlist EntryThen press the OK or √ button Editing a Scene for the Playlist Playing a Selected ScenePlay List button Modifying a Scene Replacing a Scene Press the OK button at the start point of the scenePress the OK button at the end point of the scene Adding a Scene Press the OK button at the starting point of the sceneSelected scene is moved to the selected position Copying a Playlist Entry to the Playlist Deleting a ScenePlaylist that has been selected will be copied You can create up to 999 scenes on one Deleting a Playlist Entry from the PlaylistDisc Manager Editing the Disc NameEnter the desired characters press the …† √ buttons Formatting a Disc Disc ProtectionAll title lists are deleted Delete All Title ListsDisc is finalised Finalising a discDVD-RW can be finalised or unfinalised in VR mode Unfinalising a disc V/VR modePower TroubleshootingDid you set the DVD recorder channel settings correctly? RecordingVideo PlaybackSound Timer RecordingOther Remote ControlSpecifications United Kingdom Republic of Ireland AK68-00842A-01
Top Page Image Contents