Advanced Features
¦¦ Listening through a Receiver
You can listen to sound through a receiver (i.e Home Theater) instead of the TV Speaker.
1.Select Receiver and set to On.
2.Press the EXIT button to exit.
xx If your receiver supports audio only, it may not appear in the device list.
xx The receiver will work when you have properly connected the optical in jack of the receiver to the DIGITAL AUDIO OUT (OPTICAL) jack of the TV.
xx When the receiver (i.e Home Theater) is set to On, you can hear sound output from the TV’s Optical jack. When the TV is displaying a DTV (air) signal, the TV will send out 5.1 channel sound to the receiver. When the source is a digital component such as a DVD and is connected to the TV via HDMI, only 2 channel sound will be heard from the receiver.
✎✎NOTE
xx You can only control Anynet+ devices using the TV remote control, not the buttons on the TV.
xx The TV remote control may not work under certain conditions. If this occurs, reselect the Anynet+ device. xx The Anynet+ functions do not operate with other manufacturers’ products.
¦¦ Troubleshooting for Anynet+
Problem | Possible Solution |
|
|
Anynet+ does not work. | • Check if the device is an Anynet+ device. The Anynet+ system supports Anynet+ devices only. |
| • Only one receiver (home theater) can be connected. |
| • Check if the Anynet+ device power cord is properly connected. |
| • Check the Anynet+ device’s Video/Audio/HDMI cable connections. |
| • Check whether Anynet+ |
| • Check whether the TV remote control is in TV mode. |
| • Check whether the remote control is Anynet+ compatible. |
| • Anynet+ doesn’t work in certain situations. (Searching channels, operating Media Play or Plug & Play (initial |
| setup), etc.) |
| • When connecting or removing the HDMI cable, please make sure to search devices again or turn your TV off |
| and on again. |
| • Check if the Anynet+ Function of Anynet+ device is set on. |
|
|
I want to start Anynet+. | • Check if the Anynet+ device is properly connected to the TV and check if the Anynet+ |
| On in the Anynet+ Setup menu. |
| • Press the TOOLS button to display the Anynet+ menu and select a menu you want. |
|
|
I want to exit Anynet+. | • Select View TV in the Anynet+ menu. |
| • Press the SOURCE button on the TV remote control and select a non- Anynet+ device. |
| • Press z, |
| only when a |
The message “Connecting to | • You cannot use the remote control when you are configuring Anynet+ or switching to a view mode. |
Anynet+ device...” appears on the | • Use the remote control when the Anynet+ setting or switching to view mode is complete. |
screen. |
|
The Anynet+ device does not play. | • You cannot use the play function when Plug & Play (initial setup) is in progress. |
|
|
The connected device is not | • Check whether or not the device supports Anynet+ functions. |
displayed. | • Check whether or not the HDMI cable is properly connected. |
| • Check whether Anynet+ |
| • Search Anynet+ devices again. |
| • You can connect an Anynet+ device using the HDMI cable only. Some HDMI cables may not support Anynet+ |
| functions. |
| • If connection is terminated because there has been a power interruption or the HDMI cable has been |
| disconnected, please repeat the device scan. |
|
|
The TV Program cannot be | • Check whether the antenna jack on the recording device is properly connected. |
recorded. |
|
|
|
The TV sound is not output | • Connect the optical cable between TV and the receiver. |
through the receiver. |
|