You can control your set-top-box or satellite box with the Remote Control. To establish control, you must first set up theIR extender cable. If you don'thave an STB, skip this section.
1 Connect theIR extender cable to the TV'sIR output connector.
ll ~ | | | I | ------I |
OOJ ~ | | | .... | IR Out |
| """" | I | Connect theIR Extender |
lml ~ | | ,.. ,_"" | I | : Cable here. |
~ | ~----- | I |
| ~-il | | |
~ ~· | .u;....~....(J ~~=~ | | |
I~ | ·-·-· | • [I) | | |
~ | | | Place the transmitter end |
I~ | • | | |
| | | within 4 inches of the set- |
| | | |
top-box'sremote control sensor.
- The displayed image may differ depending on the model.
2Position the transmitter end within 4 inches (1 0 em) of the set-top-box'sremote control sensor, pointing in the direction of the sensor. Make sure there are no obstacles between the transmitter end of theIR extender cable and the set- top-box or satellite box. Any obstacles will interfere with the transmission of the remote control signals.
3 Finalize control of your set-top or satellite box when you run Initial Setup.