Panasonic CF-T4 operating instructions List of Error Codes, Troubleshooting

List of Error Codes

When turning on the computer, if one of the following error codes or messages is displayed, follow the instructions shown below.

If the problem persists, or if the error code or message displayed is not shown here, contact your technical support office.

Error Code/Message		Action
0211: Keyboard error	z If an external keyboard is connected, disconnect these devices.
0251: System CMOS checksum	An error has occurred in the memory that stores the Setup Utility settings. This
bad - Default configuration used	error occurs when the memory content is changed through some inadvertent
	operation by a program or other function.
	z Run the Setup Utility and load the default values, then change the settings to
	the appropriate values as needed.
	z If the problem persists, the internal clock battery may need to be replaced.
	Contact your technical support office.
0271: Check date and time set-	The date and time setting are incorrect.
tings	z Set the date and time correctly in the [Main] menu of the Setup Utility.
	z If the problem persists, the internal clock battery may need to be replaced.
	Contact your technical support office.
0280: Previous boot incomplete -	Startup has failed repeatedly, so the Setup Utility settings have been returned to
Default configuration used	their default values, and the computer has been booted.
	z Run the Setup Utility and load the default values, then change the settings to
	the appropriate values as needed.
Press <F2> to Setup	z Write down the error details and press the			key to run the Setup Utility. Con-
			F2
	firm the settings, and change the settings to the appropriate values as
	needed.
Operating System not found	The OS is not properly installed on the floppy disk or the hard disk that you are
	trying to boot from.
	z If the computer cannot be booted from the floppy disk, check the floppy disk
	drive to ensure that the disk is in fact bootable, and change it to another if not.
	z If the computer cannot be booted from the hard disk, confirm whether the hard
	disk is properly recognized in the [Information] menu of the Setup Utility.
	•	If the hard disk is recognized (“xx GB” is displayed), perform the reinstal-
		lation procedure.
	•	If the hard disk is not recognized (“none” is displayed), contact your
		technical support office.
	z If a device is connected to the USB port, disconnect the device, or run the
	Setup Utility and set [Legacy USB Support] in the [Advanced] menu to [Dis-
	able].

Troubleshooting

33