Hard Disk Backup Function
Important Information
<To create a backup area and divide hard disk into two partitions, for OS and data>
Select [2], enter the partition size (GB), and press the Enter key.
•You can cancel this operation by pressing the 0 key.
•The data partition size will be the maximum settable size less the number entered above.
The maximum settable size will differ depending on models.
HAt the confirmation message, press the Y key. The backup area is then created.
IWhen the message [You must reboot in order to enable the Backup func- tion.] appears, remove the Product Recovery
JWhen the message [[Backup] is complete] appears, press the Ctrl + Alt
+ Del key to restart the computer.
zDo not press the Ctrl + Alt + Del key until the message is displayed. K After logging on to Windows, a message will appear advising that a new
device has been installed and that the computer must be restarted to enable the settings. Select [Yes] to restart the computer.
NOTE 
zThe [Boot] menu in the Setup Utility is set to start up from the
zThe next time the backup or restore functions are executed, follow the proce- dure for [Backing Up and Restoring Data].
Backing Up and Restoring Data
CAUTION
zBefore executing the backup function, execute a disk error check (Î page 46).
zDo not interrupt the backup or restore functions before completion, for example by turning off the power or pressing the Ctrl + Alt + Del key, as this may pre- vent Windows from starting up, or may cause data to be lost so that the backup and restore functions cannot be executed.
ATurn the computer on, and press the F2 key while [Panasonic] boot screen is displayed.
The Setup Utility will start up.
If a password has been set, enter the Supervisor Password or the User Password.
48
