Reinstalling
1 Turn off the computer and connect the
Do not interrupt the reinstallation procedure before completion, for example by turning off the computer or pressing the Ctrl + Alt + Del key, as this may prevent Windows from starting up, or may cause data to be lost so that the reinstallation procedure cannot be executed.
2 Change the settings in the Setup Utility.
Make the following settings.
zReturn settings to the status at the time of purchase.
zChange settings to enable startup from
If you change the settings from that at the time of purchase, we recommend that you make a note of the settings that are changed.
ATurn on the computer, and press the F2 key while [Panasonic] boot screen is displayed.
The Setup Utility will start up.
z If the password has been set, enter the Supervisor Password, and press the Enter key.
BPress the F9 key.
At the confirmation message, select [Yes] and press the Enter key.
CSelect the [Boot] menu, then select [USB CDD] and press the F6 key until [USB CDD] is at the top of [Boot priority order].
DPlace the Product Recovery
EPress the F10 key.
At the confirmation message, select [Yes] and press the Enter key. The Setup Utility will close, and the computer will restart.
z If the password has been set, enter the Supervisor Password, and press the Enter key.
3 Use the Product Recovery DVD-ROM to execute reinstalla- tion.
APress the 1 key to execute [1. [Recovery]]. (All of the screens below are only examples.)
<When the hard disk backup function has been enabled>
When the message [The Backup function has been enabled. If [Recovery] or [Erase HDD] is executed, the Backup function will be disabled, and your Backup data will be lost.] appears, press the Y key.
BIf you agree, press the 1 key.
If you do not agree, press the 2 key.
z If you press the 1 key the menu will be displayed.
Troubleshooting
41
