Samsung PPM42S2 manual Separating the Display from the Wall Attachment Panel

Page 9

4 Remove four large screws from the rear side of the display.

Insert the bolts and insulations into the four screwholes as shown in the follow-

5 ing figure:

Œ Bolt

´ Insulation holder

Put the insulation rubber point protruding from the rear top of the display in

6 the groove on the top of the wall attachment panel. Lift up the display a little bit so that the insulation rubber point at the bottom of the rear side of the display is put in the groove at the bottom of the wall attachment panel.

(Do not lift the display with any pressure. The insulation rubber at the top may be taken off. )

Œ

´

16

Separating the Display from the Wall Attachment Panel

Remove the fixing bolts from both sides (left and right) of the wall attachment panel. Lift and pull the bottom of the display a small amount, to separate the insulation holder point from the bottom of the wall attachment panel.

Lift the display and separate the insulation holder point from the groove on top of the wall attachment panel.

Œ

´

17

Image 9

Contents Owner’s Instructions Thank You for Choosing Samsung Important Safety InformationUser Instructions FCC InformationUser Instructions Table of ContentsSetup Your New Plasma Display Panel Remote Control Buttons Installation Notes Wall Installation InstructionsInstalling the Display on the Wall Attachment Panel Wall attachment panelSeparating the Display from the Wall Attachment Panel Viewing the Menus and Displays Turning the MonitorPDP On and OffDisplaying Status Information Displaying ClockConnections Connecting Speakers Connecting a VCR/Cable Box Connecting speakers to standsVideotape Playback Power Plug Video Y, Pb, Pr Cable Audio Cable Connecting a DVD/Set-Top BoxPicture Control To Play DVDCustomizing the Picture Using Automatic Picture SettingsPress the Menu button to exit Move the joystick left or right to change the valueSource in the cover on the remote control Selecting the PIP Screen Selecting an External SignalViewing the Picture-in-Picture Down to select PIP, then press the joystick toSelecting the Sound Source RGB mode Move the joystick up or down to select Size Move the joystick to move the PIP screen where you WantMove the joystick up or down to select Locate Move the joystick left or right to select Large or SmallWhen entering the Video mode Changing the Screen SizeFreezing the Picture Sound Control Customizing the Sound Using Automatic Sound Settings Time Setting Using the SurroundSetting the Sleep Timer Setting the ClockSetting the On/Off Timer Setting the TimersConnecting PC and Operation Pin Configuration Connecting to a PCSetting up Your Monitor Plug and Play To watch the PC screen848 X 60.000 29.800 How to Set up Your PC Software Windows onlyAdjusting the R.G.B Adjusting the PC ScreenTo enter Press the joystick to enterEnlarging the Image Zoom Moving the Zoom Picture Picture Automatic Adjustment On/Off Changing the Size of the Image Picture Quality AdjustmentFine Tuning Phase Frequency AdjustmentPower Saver RGB mode only Function DescriptionHorizontal Sync Numeric buttons Selecting a Menu Language Setting the Multi ControlDigital Noise Reduction Auto Power OnSetting up Your Remote Control Using the Panel LockRemote Control Codes Multiple Display ControlVCR Codes Cable Box Codes DVD Codes Introduction InstallationInstallation Continue Beginning-Confirming the Port Main ScreenBeginning-Changing the Port Power ControlInput Source Control Selection Screen of Power ControlAspect Ratio Screen of Video/S-Video Switches the input source of the selected display into RGB2Aspect Ratio Screen of RGB1, RGB2 Time ControlSettings Control-Picture RGB Settings Control-PictureSettings Control Screen Audio Settings Control-AudioTroubleshooting Appendix Care and Maintenance Memo Specifications