Setup, Basic, Learning Method | Universal Remote Control RF30

Learning Method

The RF30 can actually ‘learn’ commands from other remote controls (old or new), one-button-at-a-time, so it will never become obsolete. RF30 is the last remote you’ll ever need! Just follow these simple steps:

Learning Method

SETUP

STEP 1:

Line-up the RF30 with the other remote control, head-to-head, one or two inches apart.

STEP 2:

On the RF30, press and hold the MAIN and ENT (Enter) buttons at the same time for approxi- mately three seconds, until the word “SETUP” is displayed at the top of the LCD touch screen. This signals you are now in SETUP mode.

IMPORTANT:

You now have 30 seconds to perform the next step while you are in SETUP mode. If you don’t press a button within 30 seconds, SETUP will disap- pear from the screen, signaling that you have exited setup mode and you will need to start over.

STEP 3:

Press the LEARN button on the LCD screen. The top of the screen will change to “LEARN” and display the seven Components (and FAV) from Page 1 of the MAIN menu.

To display Page 2 of the MAIN menu that lists an additional eight Components, simply press the (or) Page buttons at the bottom of the screen.

STEP 4:

Select the Component you want to teach commands to by pressing that Component button on the LCD screen (in this example, TV). The top of the screen will change to “TV”.

NOTE: If you want to teach any com- mand to a Component button, press the Component button once the top of the screen displays “MAIN”, by pressing the PAGE button. The top of the screen will change to "READY". Then go to STEP 6.

BASIC

MAIN

BUTTON

ENTER

BUTTON

LEARN

BUTTON

SETUP