Universal Remote Control RF30 manual Pre-Programmed Code Method, Basic Setup Overview

7					8
Overview & Programmed-Pre Code Method	Basic Setup - Overview				Pre-ProgrammedCodeMethod
	button at a time.
	There are two ways to program the RF30:
	• The Pre-Programmed Code Method
	• The Learning Method
	The Pre-Programmed Code Method allows you to set up
	all the buttons at once, so it’s the fastest and easiest of
	the two methods. The Learning Method allows you to
	transfer functions from other remotes (old or new), one
	Pre-Programmed Code Method
	STEP 1:	STEP 2:	STEP 3:
	The pre-programmed 3-digit	Now, turn on the Component	Press and hold the MAIN and ENT
	codes are found in the back of	you want to program... let’s say	(Enter) buttons at the same time
	this Manual on page 44. The	your TV to start. Look up your	for approximately 3 seconds, until
	codes are listed by Component	TV’s manufacturer setup code	the word “SETUP” is displayed at
	category (i.e., TV, VCR, DVD,	from your reference list.	the top of the LCD touch screen.
	etc.), then by brand name. For		This signals that you are now in
	instance, if you want to locate		setup mode.
	a code for a Sony TV, first
	locate the TV category, and
			IMPORTANT:
	then look for the Sony brand.
			You now have 30 seconds to perform
			the next step while you are in SETUP
	Once you have located the		mode. If you don’t press a button
			within 30 seconds, SETUP will disap-
	3-digit code (or in some cases,		pear from the screen, signaling that
			you have exited setup mode and you
	several code numbers) for the
			will need to start over.
	Component that you want to
SETUP	operate with your RF30, write				BASIC
	them ALL down on a piece of
	note paper. It’s important that
	you write down all the codes
	because only one code is going
	to work for you.
BASIC					SETUP
				MAIN
				BUTTON
				ENTER
				BUTTON