Universal Remote Control M1055 manual RE-ASSIGNING Device Keys, To Clear The Master Power Key

Atlas DVR-PVR M1055 8/12/04 4:51 PM Page 19

To Clear The Master Power Key:

1.Perform steps 1 and 2 in the first section above, To Program The Master Power Key.

2. To clear the settings and exit the program, press and hold SETUP until the CBL key blinks twice, then release SETUP.

RE-ASSIGNING DEVICE KEYS

The Atlas DVR/PVR 5-Device Universal Remote Control can be set up to control a second device. For example, to have the unit control a TV, a Cable Converter, and two DVD Players, you will need to re-assign the unused AUX key to operate the second DVD Player as follows:

NOTE: AUX is preset at the factory to control an RCA VCR. Performing the below steps will overwrite those settings.

1.On the remote control, press AUX once; it will blink once. Then press and hold SETUP until

the AUX key blinks twice, then release SETUP.

2. Enter 9 - 9 - 2. The AUX key will blink twice.

3. Press DVD once, then press AUX once. The AUX key will blink twice.

4.The AUX key is now ready to be programmed for your second DVD player. See Programming Device Control on page 10.

To re-assign other device keys, repeat steps 1 to 4 and substitute the key sequence using the following chart:

NOTE: Only one device can be assigned to an unused device key at a time.

continued on next page...

19