Atlas DVR-PVR M1055 8/12/04 4:51 PM Page 10
PROGRAMMING DEVICE CONTROL
The Atlas DVR/PVR
NOTES: For TV/VCR Combo control, skip this section and perform the instructions on page 12. Also refer to the “Device Table” on page 8 to find out which devices can be programmed onto each device key.
If you have another brand of cable converter or a satellite receiver you would like to control, you’ll first need to unlock the cable ID Lock before changing the converter code – see “Programming ID Lock” on page 16.
1.Turn on a device and, if applicable, insert video media, (e.g., cassette or disc).
NOTE: Please read steps 2 through 4 completely before proceeding. Highlight or write down the codes and device you wish to program before moving on to step 2.
2.On the remote control, press a device key once (i.e.., AUX, DVD, AUD, TV, or CBL); it will blink
once. Then press and hold SETUP until the selected mode key blinks twice, then release
SETUP.
3.Use the Manufacturer’s Codes (starting on page 24) to locate the the type of device and brand name and then enter the first
NOTE: If the selected mode key emits a long blink, the entry is invalid. Repeat steps 2 through 3 and try entering the same code again.
4.Aim the remote control at the device and
press PWR once. The device should turn off. If it does not, repeat steps 2 through 3, trying each code for your brand until you find one that works. If it still does not respond, try searching for the code (see Searching For Your Code on page 13).
NOTE: If the device does not have a POWER key, press the 
(Play) key.
10