Toshiba 51H93 owner manual Labeling the video input sources

Chapter 8: Using the TV’s features

Labeling the video input sources

You can label each video input source according to the type of device you connected to each source, from the following preset list of labels:

– – (default label)

Audio Receiver

VCR

Video Recorder

Input labeling example:

If you connect a VCR to VIDEO 1, a DVD player to ColorStream HD-1, and a high-definition device to DVI/HDCP, and then label the video input sources accordingly (as shown in step 4 at left), when you press INPUT or TV/VIDEO, the INPUT SELECTION screen would then look like the screen below right:

Laser Disk

Compact Disc

DVD

DTV

SAT (Satellite box)

CBL (Cable box)

DVI (DVI/HDCP device)

Note:

Input Selection

O : ANT 1

1 : Video 1

2 : Video 2

3 : Video 3

4 : ColorStream HD 1

5 : ColorStream HD 2

6 : DVI

7 : ANT 2

0 – 7: TO SELECT

Input Selection screen with no inputs labeled

Input Selection

O : ANT 1

1 : VCR

2 : Video 2

3 : Video 3

4 : DVD

5 : ColorStream HD 2

6 : HD

7 : ANT 2

0 – 7: TO SELECT

Input Selection screen with inputs 1, 4, and 6 labeled

•If you set up devices in TheaterNet, the associated inputs are automatically labeled and cannot be relabeled until you remove the device from TheaterNet (see page 45).

•You cannot select IEEE-1394 devices through the INPUT SELECTION window; however, you can select and control IEEE-1394 devices through TheaterNet (see page 45).

To label the video input sources:

To clear the video labels:

1.Press MENU and open the PREFERENCES menu.

2.Highlight INPUT LABELING and press ENTER.

3.Highlight RESET and press ENTER.

4.Highlight SAVE and press ENTER.

1.Press MENU and open the PREFERENCES menu.

2.Highlight INPUT LABELING and press ENTER.

Preferences

Favorite Channels

Closed Caption Mode • • • Off

Closed Caption Advanced

Preferences

Favorite Channels

Closed Caption Mode • • • Off

Closed Caption Advanced

Input Labeling

Menu Language • • • • English

Input labeling
Video 1		VCR
Video 2		– –
Video 3		– –
ColorStream HD1		– –
ColorStream HD2		– –
DVI		– –
Save	Cancel	Reset

Input Labeling

Menu Language • • • • English

3.Press z or y to highlight the video source you want to label.

4.Press x or • to select the desired label for that input source.

Input labeling
Video 1		VCR
Video 2		– –
Video 3		– –
ColorStream HD1		DVD
ColorStream HD2		– –
DVI		HD
Save	Cancel	Reset

5. To save the labels, highlight SAVE and press ENTER.

Note: Labels for devices you set up in TheaterNet will not be cleared until you remove the device from TheaterNet (see page 45). The screen above right illustrates an example of the Input Labeling screen after it was reset that still shows the VCR label for VIDEO 1 because the VCR was set up in TheaterNet.

62 Copyright © 2003 TOSHIBA CORPORATION. All rights reserved.