Preparing and using the remote control Placement

Preparing and using the remote control

Placement

■Loading dry-cell batteries

into the remote control

qRemove the battery cover.

■Operating the remote control

Point the remote control toward the projector’s infrared remote sensor, and press a button on the remote control.

•Operating the projector from the front

Placement Styles

As shown in the figures below, this device can be placed in 4 different styles.

The factory setting is “floor-mounted front projection.” Set the placement style in the default setting menu p.32 , in accordance with your needs.

Floor-mounted front projection

wInsert the dry-cell batteries.

	Be sure to align the plus and minus	Approx. 15°
	ends of the batteries properly.	Approx. 15°
	ends of the batteries properly.	A
		A
		pprox.
		5m

• Operating the projector from the rear

Two batteries (R03, SIZE AAA) are used.

eReplace the battery cover.

Ceiling-mounted front projection

Ceiling-mounted rear projection

Preparations

Approx. 15°

Approx. 5m

Dry-cell batteries

•Before using the batteries, be sure to observe the Safety Precautions described in previous pages.

•Remove batteries from remote control when not using for extended periods.

•If the remote control stops working, or if its range decreases, replace all the batteries with new ones.

The remote control

•The remote control may fail to operate if the infrared remote sensor is exposed to bright sunlight or fluorescent lighting.

•Do not drop or bang.

•Do not leave in hot or humid locations.

•Do not get wet or place on top of wet objects.

•Do not take apart.

•In rare cases, ambient conditions could impede the operation of the remote control. If this happens, point the remote control at the main unit again, and repeat the operation.

•For further information of the mouse remote control supplied with the TLP-T60M, TLP- T61M, TLP-T70M, TLP-T71M, see the Owner’s Manual of the Mouse Remote Control.

CAUTION

•Always obey the instructions listed in IMPORTANT SAFETY INSTRUCTIONS when placing the unit.

•If you wish to mount the projector on the ceiling, be sure to ask your dealer to do so. Mounting the projector on a ceiling requires special ceiling brackets (sold separately) and specialized knowledge. Improper mounting could cause the projector to fall, resulting in an accident.

•If the projector is ceiling-mounted, install the breaker for turning off the power in case of anomaly. Let everyone involved with the use of the projector know that.fact.