Toshiba 72MX196 manual Manually adding and deleting channels in the channel memory

MX196_EN.book Page 27 Tuesday, June 27, 2006 1:43 PM

Chapter 4: Setting up your TV

Manually adding and deleting channels in the channel memory

After automatically programming channels into the channel memory, you can manually add or delete individual channels.

To add or delete channels in the channel memory:

1 Press Yand open the Setup menu.

2 Highlight Installation and press T.

3 (A new set of Installation menu icons will appear, as shown below.) Open the Terrestrial menu, highlight Channel Add/Delete, and then press T.

Terrestrial

Input Configuration

Channel Program

Channel Add/Delete

Signal Meter

Navigate ENTER Select CH RTN Back EXIT Exit

4 The illustration below left shows channels programmed for the ANT 1 antenna input. To view the list of channels programmed for the ANT 2 or Cable box antenna input, press Bb to highlight ANT 2 and press T.

Channel Add/Delete				Channel Add/Delete
	2	Analog	ANT 1		1	Analog	ANT 1
	2 - 1	Digital	ANT 2		2	Analog	ANT 2
	2 - 2	Digital			3	Analog
	3	Analog			4	Analog
	4	Analog			5	Analog
	5	Analog			6	Analog

6	Analog		7	Analog
7	Analog	Reset	8	Analog	Reset

7 - 1	Digital	Cancel	9	Analog	Cancel
8	Analog	Done	10	Analog	Done

To add a channel to the channel memory:

Highlight the unchecked box next to the channel number you want to add, and then press Tto check the box.

To manually add digital subchannels on a physical channel:

Use the Channel Numbers and the Dash (=) on the remote control to enter the channel number (for example, 56–1).

If the channel is found, the number will be added to the list and the box will be checked.

If the channel is not found, a message will appear.

To remove a channel from the channel memory:

Highlight the checked box next to the channel number you want to remove, and then press Tto uncheck the box.

To save your new settings:

Highlight Done and press T.

To revert to your original settings:

Highlight Cancel and press Tbefore saving.

To remove all channels from the channel memory:

Highlight Reset and press T, and then highlight Done and press T.

Channel Add/Delete

2	Analog	ANT 1
2 - 1	Digital	ANT 2
2 - 2	Digital
3	Analog
4	Analog
5	Digital
6	Analog
7	Analog	Reset
7 - 1	Digital	Cancel
8	Analog	Done

Note: This action applies to the current antenna input only. To delete/add channels on the other input, highlight the other input and press T.

27

MX196 (E/F) Web 213:276

Downloaded from www.Manualslib.com manuals search engine