Toshiba 65NH84 owner manual Care, Service

Page 4

25)Always operate this equipment from a 120 VAC, 60 Hz power source only.

26)Always make sure the antenna system is properly grounded to provide adequate protection against voltage surges and built-up static charges (see Section 810 of the National Electric Code).

31) [This item applies to projection TVs only.] If the air

temperature rises suddenly (for example, when the TV is

first delivered), condensation may form on the lenses. This

can make the picture appear distorted or the color appear

faded. If this happens, turn off the TV for 6 to 7 hours to

allow the condensation to evaporate.

32) For added protection of your TV from lightning and power

surges, always unplug the power cord and disconnect the

antenna from the TV if you leave the TV unattended or

unused for long periods of time.

Ground clamp

Electric service equipment

Ground clamps

Antenna lead-in wire

Antenna discharge unit (NEC Section 810-20)

Grounding conductors (NEC Section 810-21)

Power service grounding

electrode system (NEC Art 250 Part H)

33) During normal use, the TV may make

occasional snapping or popping

sounds. This is normal, especially

when the unit is being turned on or

off. If these sounds become frequent

or continuous, unplug the power cord

and contact a Toshiba Authorized Service Center.

34) Possible Adverse Effects on TV Picture Tube: If a fixed

(non-moving) pattern remains on the TV screen for long

periods of time, the image can become permanently

27)DANGER: RISK OF SERIOUS PERSONAL

INJURY OR DEATH!

• Use extreme care to make sure you are never in a position where your body (or any item you are in contact with, such as a ladder or screwdriver) can accidentally touch overhead power lines. Never locate the antenna near overhead power lines or other electrical circuits.

•Never attempt to install any of the following during lightning activity:

a) an antenna system; or b) cables, wires, or any home theater component connected to an antenna or phone system.

Care

For better performance and safer operation of your TOSHIBA TV, follow these recommendations and precautions:

engrained in the picture tube and cause subtle but

permanent ghost images. This type of damage is NOT

COVERED BY YOUR WARRANTY. Never leave your TV

on for long periods of time while it is displaying the

following formats or images:

• Fixed Images, such as PIP/POP windows, stock tickers,

video game patterns, TV station logos, and websites.

• Special Formats that do not use the entire screen. For

example, viewing letterbox style (16:9) media on a

normal (4:3) display (gray bars at top and bottom of

screen); or viewing normal style (4:3) media on a

widescreen (16:9) display (gray bars on left and right

sides of screen).

Service

28) Always sit approximately 10–25 feet away from the TV and

as directly in front of it as possible. The picture can appear

dull if you sit too far to the left or right of the TV, or if

sunlight or room lights reflect on the screen. Turn the TV

off to check for reflections on the screen, and then remove

the source of reflections while viewing the TV.

35)WARNING: RISK OF ELECTRIC SHOCK! Never attempt to service the

TV yourself. Opening and removing the covers may expose you to dangerous voltage or other hazards. Refer all servicing to a Toshiba Authorized Service Center.

QUALIFIED

SERVICE

TECHNICIAN

29) Always unplug the TV before

 

cleaning. Never use liquid or

 

aerosol cleaners. Clean only with

 

a dry cloth.

 

 

30)

WARNING: RISK OF ELECTRIC SHOCK!

Never spill liquids or push objects of any kind into the TV cabinet slots.

36)If you have the TV serviced:

•Ask the service technician to use only replacement parts specified by the manufacturer.

•Upon completion of service, ask the service technician to perform routine safety checks to determine that the TV is in safe operating condition.

37)When the TV reaches the end of its useful life, ask a qualified service technician to properly dispose of the TV. Improper disposal may result in a picture tube implosion and possible personal injury.

40303

Page 3 Page 5
Image 4
Page 3 Page 5
Contents Projection Television Safety Precautions Dear CustomerImportant Safety Instructions InstallationService CareImportant Safety Precautions for Split Cabinet Feature Important Safety Information Introduction Welcome to Toshiba Exploring your new TVConnecting an antenna or cable TV Connecting your TVConnecting a VCR Connecting a cable converter boxConnecting a cable converter box and VCR Connecting a DVD player or satellite receiver and a VCR From Antenna Stereo VCR From DTV Antenna Connecting two VCRs Connecting a camcorderOne Hdmi cable type a connector Connecting an Hdmitm or a DVI device to the Hdmi inputOne pair of standard analog audio cables Connecting an audio system Preparing the remote control for use Installing the remote control batteriesUsing the Remote Control Remote Control functional key chartCBL/SAT Audio VCR TV/VCR TV/SAT Device code setup Searching and sampling the code of a deviceUsing the volume lock feature Operational feature resetConnecting YourTV Usingthe RemoteControl Setting up your TV FeaturesVCR setup codes Device code tableCD Player setup codes Learning about the remote control Connecting TVyour Learning about the menu systemChanging the on-screen display language Selecting the antenna inputPress y or z to highlight your desired language Display the pull-down menuIntroduction Connecting YourTV Adding channels to the TV’s memoryProgramming channels automatically To program channels automaticallyAdding and erasing channels manually Changing channelsUp TV Adjusting the color convergence Introduction Connecting your TVManually adjusting the color convergence Setting up your TV Using the TV’s FeaturesTo reset your adjustments Adjusting the channel settings Switching between two channels using Channel ReturnSwitching between two channels using SurfLock Programming your favorite channelsFavorite CH Press y or z to highlightPress Enter to display the Favorite CH menu Introduction Connecting YourTV Usingthe RemoteControl Settingup yourTVUsingtheTV’s Features Appendix Labeling channelsSelecting the picture size Natural picture sizeSetting your Usingthe RemoteControlUsingtheTV’s Features To raise the picture, press y Press Enter to display the Scroll Adjustment modeTo lower the picture, press z Using the Auto Aspect feature Setting Your UsingtheTV’s Features Appendix IndexPress y or z to highlight Auto ASPECT, and then press EnterUsing the POP double-window feature POP Source Select I onSwitching the main and POP pictures Switching the speaker audio main or POPUsing the programmed channel search function Double-Window aspect ratioUsing the favorite channel search function About the auto favorite featureUsing the Locks menu Using the V-CHIP menuEntering the PIN code If you cannot remember your PIN codeEnable Blocking OFF To release your setting UnlockTV Rating Independent rating system for broadcasters Press z or y to select an itemMpaa Rating Independent rating system for movies Mpaa RatingUsingthe RemoteControl Settingup YourTV Locking channelsUnlocking programs temporarily Repeat steps 2 and 3 for other channelsPress y or z to highlight Clear ALL, and then press Enter Locking the video inputs Changing the PIN codeOFF Press Enter New PIN code is now activeSelecting the picture mode Adjusting the pictureAdjusting the picture quality Selecting the color temperature Picture Settings menu appearsPress x or to select the mode you prefer Saving your new preferencesUsing the CableClear DNR feature Resetting picture adjustments Selecting the display format for 480p signals onlyTheTV’s Features Selecting the cinema modeSelecting the video input source Press y or z to highlight Caption or TEXT, and then press Using the closed caption featureTo view text, highlight T1, T2, T3, or T4 Setting the on timer Setting the sleep timerTo set the clock Press y or z to highlight Clock SET, and then press EnterPress Enter to start the clock To display the time on-screen Press RecallMuting the sound Adjusting the soundSelecting stereo/SAP broadcasts Using the WOW surround sound feature Adjusting the sound qualityPress y or z to adjust the item, then press Enter Audio Settings menu appearsResetting your audio adjustments Using the StableSound featureTo turn off the StableSound feature Select OFF in above CenterConnecting Your Control Using RemoteSettingup YourTV UsingtheTV’s Features Appendix Index Turning off the built-in speakersUnderstanding the auto power off feature Understanding the last mode memory featureSelecting the background of the menu display Displaying on-screen informationSpecifications AppendixTroubleshooting AntennaBlack box appears on the screen T2, T3, or T4. Turn closed captioning OFFLimited United States Warranty Limited Canada Warranty Page Page Index Manufactured by
Top Page Image Contents