Toshiba 53AX62 owner manual Adjusting the color convergence, Usingthe RemoteControl

Adjusting the color convergence

This projection TV uses three separate TV tubes: red, green, and blue. The red, green, and blue images are projected onto the screen where they converge to form a full-color picture. You can see a clear picture only when the three images converge correctly. Convergence may drift over time or if you move the TV. (If the image on your screen is clear, skip this procedure.)

To adjust the color convergence:

Note: The TV must be on for at least 30 minutes before adjusting the color convergence.

1.Press MENU, and then press x or • until the PICTURE menu appears.

2.Press y or z to highlight CONVERGENCE (below left).

3.Press x or • to display the center CONVERGENCE menu (below right). If you see separate red, blue, or green crossed lines, you should adjust the convergence.

Number

MENU/

ENTER

yzx •

EXIT

Introduction
Connecting	yourTV

P I CTURE ANTENNA

MODESPORTS

FLESH TONE	ON
NO I SE REDUCTION	OFF
COLOR	COOL
TEMPERATURE
CONVERGENCE

SAVE NEW PREFERENCE

3

RED	BLUE
ENTER : TO SELECT			COLOR
EX I T : TO		SELECT	POS I T I ON

Usingthe RemoteControl

2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 3

4.Press ENTER to highlight RED or BLUE, depending on which color needs adjusting. If both red and blue need adjusting, you must perform steps 4 and 5 twice.

5.Press y (up), z (down), x (left), or • (right) on the remote control to converge the red or blue line into the green line. When correctly adjusted, you will see two single crossed white lines.

6.Press EXIT to display the circumference CONVERGENCE menu.

7.Press the corresponding Number button (1Ð4 and 6Ð9) to select the area you want to adjust (below left).

8.Press ENTER to highlight RED or BLUE, depending on which color needs adjusting (below right). If both red and blue need

adjusting, you must perform steps 8 and 9 twice.

3 3

Settingup	yourTV
theTV’s	Features

1	2	3
4		6
PUSH	1 – 9
7	8	9

RED BLUE
ENTER : TO SELECT	COLOR
EX I T : TO SELECT	POS I T I ON

Using

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 3

9.Press yzx • to converge the red or blue line into the green line, until you see two single crossed white lines.

10.To select another area to adjust, press EXIT once, and then repeat steps 7 through 9.

11.To close the CONVERGENCE menu, press EXIT twice.

Appendix

27