Toshiba 62HM15A, 46HM15 owner manual Viewing the digital signal meter, Viewing the system status

Chapter 6: Setting up your TV

Viewing the digital signal meter

You can view the digital signal meter for the ANT 1 and ANT 2 digital TV input sources only.

To view the digital signal meter:

1.Press MENU and open the Setup menu.

2.Highlight Installation and press ENTER. (A new set of Installation menu icons will appear on-screen, as shown in step 3 below.)

Setup

Installation
Sleep Timer
On/Off Timer
HDMI 1 Audio		Auto
HDMI 2 Audio		Auto
Slide Show Interval		2 Sec
AVHD Skip Time		15 min
Navigate	Select CH RTN Back EXIT Exit

3.Open the Terrestrial menu, highlight Signal Meter, and press ENTER.

Terrestrial

Input Configuration

Channel program

Channel Add/Delete

Signal Meter

Navigate Select CH RTN Back EXIT Exit

4.Use the yzx • buttons to select the antenna input and digital channel whose signal you want to check.

Note: The physical digital channel number listed in the Signal Meter screen may not correspond to a virtual TV channel number. Contact your local broadcasters to obtain the RF channel numbers for your local digital stations.

Signal Meter

Signal Locked
	0	Peak 0
Antenna		1
Physical Digital Channel		13
Virtual Digital Channel		N/A
	O K

To close the screen and return to the Terrestrial menu:

Highlight OK and press ENTER.

To return to normal viewing:

Press EXIT.

Viewing the system status

To view the system status:

1.Press MENU and open the Setup menu.

2.Highlight Installation and press ENTER. (A new set of Installation menu icons will appear on-screen, as shown below right).

Setup				System Status
Installation				System Infomation
Sleep Timer
On/Off Timer
HDMI 1 Audio			Auto
HDMI 2 Audio			Auto
Slide Show Interval			2 Sec
AVHD Skip Time			15 min
	Navigate	Select CH RTN Back EXIT Exit			Navigate	Select CH RTN Back EXIT Exit

3.Open the System Status menu, highlight System Information, and then press ENTER.

4.Use the x • buttons to scroll through the menu bar to check the Product Information and Software Version.

System Information				System Information
	Product Information				Software Version
	Brand:		Toshiba		0.3.0
	Model:		52HM95
					Mar 9 2005 - 12:37:10
	IEEE1394 GUID:	00003914-28343803				FW:0.12
						Sub:47
		O K				O K

To close the screen and return to the Installation menu:

Highlight OK and press ENTER.

To return to normal viewing:

Press EXIT.

Restore Factory Defaults

To restore all settings and channels to their factory default values:

1.Follow steps 1–3 above.

2.Use the x • buttons to scroll through the menu bar to select Factory Defaults.

3.Enter your PIN code (or 0000 if no PIN code has been set).

4.Highlight Yes and press ENTER. The TV will turn off automatically after a few seconds. After the TV turns off, unplug the TV power cord and then plug it in again to complete the restore process.

To cancel the reset:

Highlight No and press ENTER.

52 Copyright © 2005 TOSHIBA CORPORATION. All rights reserved.