Toshiba 46HM95 Your TV has ColorStream component video inputs, To view antenna or Cable channels

Chapter 2: Connecting your TV

Connecting a DVD player with ColorStream® (component video) and a VCR

Your TV has ColorStream® (component video) inputs.

You will need:

￿one signal splitter

￿three coaxial cables

￿two sets of standard A/V cables

•For better picture performance, if your VCR has S-video, use an S-video cable (plus the audio cables) instead of the standard video cable. However, do not connect both types of video cable to VIDEO 1 (or VIDEO 2) at the same time or the picture performance will be unacceptable.

•If you have a mono VCR, connect L/MONO on the TV (VIDEO 1) to your VCR’s audio out terminal using the white audio cable only.

￿one pair of standard audio cables

￿one set of component video cables

•You can connect the component video cables (plus audio cables) from the DVD player to either set of ColorStream terminals on the TV (HD-1 or HD-2). The ColorStream HD-1 and HD-2 terminals can be used with Progressive (480p, 720p) and Interlaced (480i, 1080i) scan systems. A 1080i signal will provide the best picture performance.

•If your DVD player does not have component video, see page 16. If your DVD player has HDMI video, see page 19.

￿To view antenna or Cable channels:

Select the ANT 1 video input source on the TV.*

￿To view the DVD player:

Turn ON the DVD player. Select the ColorStream HD-1 video input source on the TV.*

￿To view the VCR:

Turn ON the VCR. Select the VIDEO 1 video input source on the TV.*

￿To record a TV program while watching a DVD:

Turn ON the VCR. Tune the VCR to the channel to record. Select the ColorStream HD-1 video input source on the TV* to view the DVD.

_____________

*To select the video input source, press INPUT on the remote control (see page 67). To program the TV remote control to operate other devices, see Chapter 3.

The unauthorized recording, use, distribution, or revision of television programs, videotapes, DVDs, and other materials is prohibited under the Copyright Laws of the United States and other countries, and may subject you to civil and criminal liability.

From antenna or Cable

Signal splitter IN

OUT

OUT
Stereo VCR
	VIDEO
IN from ANT	L
CH 3	IN
CH 4
OUT to TV	OUT
	R
TV
	OUT

				AUDIO
Y	PB	PR		OUT
				L
S-VIDEO COMPONENT VIDEO			VIDEO	R
OUT			OUT

DVD player with component video

Note: The VIDEO/AUDIO OUT terminals output signals from the ANT 1, ANT 2, VIDEO 1, VIDEO 2, and VIDEO 3 terminals when the appropriate input mode is selected.

￿To use the TV Guide On Screen® recording features:

1.Connect the G-LINK®cable according to the instructions on page 25.

2.Make sure the VCR is connected to the A/V OUT terminals on the TV (see illustration).

3.Set the VCR to the appropriate line input (refer to your VCR owner’s manual for details), and then turn OFF the VCR.

4.See Chapter 5 for details on setting up the TV Guide On Screen® system.

5.See Chapter 7 for details on using the TV Guide On Screen® system.

		Copyright © 2005 TOSHIBA CORPORATION. All rights reserved.	17
HM95_R1_012-25_061505	17	6/24/05, 9:12 PM

(E) 46/52/62HM95