Toshiba 46HM95 owner manual IEEE1394 device management, To edit the IEEE1394 device information

Chapter 2: Connecting your TV

Connecting IEEE1394 video devices (continued)

IEEE1394 device management

The IEEE1394 device information is saved in the TV’s memory. You can edit this device information (for example, edit the device name, change the analog input information, or delete the device information from the TV’s memory if you no longer use that device).

To edit the IEEE1394 device information:

1.Press MENU and open the Setup menu.

2.Highlight Installation and press ENTER. (A new set of Installation menu icons will appear on-screen, as shown in step 3 below).

Setup

Installation
Sleep Timer
On/Off Timer
HDMI 1 Audio		Auto
HDMI 2 Audio		Auto
Slide Show Interval		2 Sec
AVHD Skip Time		15 min
Navigate	Select CH RTN Back EXIT Exit

3.Open the Devices menu, highlight IEEE1394 Devices, and press ENTER.

Devices

IEEE1394 Devices

TheaterNet Devices

Important information regarding IEEE1394

device interconnection

•Never loop the last device in the chain back to the TV.

If the device chain is looped, the TV may not work properly with the other devices in the chain.

•Always place devices with the slowest communication speed at the end of each chain. If a device with a slower communication speed is placed ahead of a faster device in the chain, the signal from the slower device will interfere with the signal from the faster device. To determine the communication speed of an IEEE1394 device, look for an “S” number near the device’s IEEE1394 connector. The higher the “S” number, the faster the device. If your device is not marked with an “S” number, look in the device’s user manual or call the device manufacturer’s technical support number.

•If your IEEE1394 device has a two-position power switch, always place the device at the end of the chain and turn ON the power switch when any device is used. If the power switch is OFF, it will interfere with signals from devices behind it in the chain.

•The maximum length for an IEEE1394 cable between each device is 15 feet.

•This TV is an IEEE1394A device. The IEEE1394B protocol is faster and intended to allow for longer distances between devices and multi-room systems. IEEE1394A–to–IEEE1394B converters (available at some electronics suppliers) may allow compatibility of IEEE1394B devices with your existing IEEE1394A devices.

•The transmission capability of IEEE1394 cable used with this TV must be S400 (400 Mbps maximum).

Navigate Select CH RTN Back EXIT Exit

4. Highlight the device you want to edit and press ENTER.

IEEE1394 Device Management

Brand	Type	Label	Analog Input Used	Connected
TOSHIBA	AVHD	MY DEVICE	None	No

Reset

Done

5.Follow the on-screen prompts to modify the device information.

24		Copyright © 2005 TOSHIBA CORPORATION. All rights reserved.
HM95_R1_012-25_061505	24	6/24/05, 9:13 PM

(E) 46/52/62HM95