Cisco Systems AIR-ANT2414S-R specifications Attaching the Mounting Brackets to the Antenna

Step 7 Install two mast mount clamps on the 4-inch ¼-20 hex head bolts as shown in Figure 1. Step 8 Install a ¼-20 split lock washer and hex head nut on each bolt and tighten hand tight. Step 9 Go to Step 1 and assemble the second mounting bracket.

Figure 1 Mounting Bracket Assembly

7

6

1

2 3

117177

5

4

4

1	Antenna bracket (adjustable bracket shown)	5	Hex head bolt
2	¼-20 x ¾-in (1.9 cm) hex head nut	6	¼-20 x ¾-in (1.9 cm) hex head bolt
3	Mast mount clamp plate	7	¼-20 x 4-in hex head bolt details
4	Mast mount clamp

Attaching the Mounting Brackets to the Antenna

The antenna has studs onto which you attach the installed mounting brackets to it. The adjustable bracket is installed on the top set of studs. Follow these steps to attach the mounting brackets to the antenna.

Step 1 Position the antenna so that the arrow on the orientation label is pointed up. The arrow points to the top of the antenna so that it can be installed correctly.

Note The orientation label is located on the back panel of the antenna.

Step 2 Attach the adjustable mounting bracket to the top set of mounting studs.

Step 3 Install two split lock washers and hex nuts on the studs. Use a 7/16-in. socket or wrench to tighten the nuts. Do not overtighten.

Step 4 Attach the non-adjustable mounting bracket on the bottom set of mounting studs.

Step 5 Install two split lock washers and hex nuts on the studs and tighten as described in Step 3.

Cisco Aironet 14-dBi Vertically Polarized Sector Antenna (AIR-ANT2414S-R)

6 78-16403-01