Panasonic DMR-PWT635 Easy Network Setting, Wired connection, Wireless connection, WPS Push button

Getting started

Easy Network Setting

After completing “Easy Setting”, you can continue with “Easy Network Setting”.

1 Select “Wired” or “Wireless”, then press [OK].

[PWT635]

Easy Network Setting

Settings and tests for connection required for home network and the Internet will be conducted.

First, please select a connection mode.

Current setting : Wired

LAN cable connection:

Connect a LAN cable to the unit and select “Wired”.

Wireless LAN connection:

Select “Wireless”.

Wired

Wireless

OK

RETURN

2 Follow the on-screen instructions and make

the following confirmation and settings.

“Wired” connection:

-Home Network Connection Check

-Home Network function

-Remote Recording function

-Internet Connection Test

“Wireless” connection:

•Before beginning wireless connection setup obtain your Network name (SSID). An SSID (Service Set IDentification) is a name used by wireless LAN to identify a particular network. Transmission is possible if the SSID matches for both devices.

•[PWT530] If “Wireless LAN Adaptor is not connected.” is displayed, check that the Wireless LAN Adaptor is fully inserted.

Alternatively, disconnect and reconnect it. If there is still no change in the display, consult your dealer for advice.

-Wireless Settings

-Home Network Connection Check

-Home Network function

-Remote Recording function

-Internet Connection Test

3 When “Easy Network Setting is finished.” appears.

Press [OK].

Connection method to wireless access point

Search for wireless network:

1Select “Search for wireless network”, then press [OK].

2The available wireless networks will be displayed. Select your network name and press [OK].

-If your Network name is not displayed search again by pressing the red button on the remote control.

-Stealth SSID will not be displayed. Enter manually by using “Wireless Settings”. (> 68, 78)

•If your wireless network is encrypted, Encryption Key Input Screen will be displayed.

Input the encryption key of your network.

WPS (PUSH button):

If your Wireless router supports WPS (PUSH button), you can easily perform the settings by pressing WPS button on it.

WPS (Wi-Fi Protected Setup™) is a standard that facilitates settings relating to the connection and security of wireless LAN devices.

1Select “WPS (PUSH button)”, then press [OK].

2Press WPS button or corresponding button of Wireless router until the lamp starts flashing.

e.g.,

•Wi-Fi Protected Setup™-compatible Wireless router may have the mark.

•For details, refer to the operating instruction of Wireless router.

3Press [OK].

VQT4L30 21