Panasonic DMP-B100 operating instructions Important Safety Instructions, Bottom of product

Page 2

IMPORTANT SAFETY INSTRUCTIONS

Read these operating instructions carefully before using the unit. Follow the safety instructions on the unit and the applicable safety instructions listed below. Keep these operating instructions handy for future reference.

1)Read these instructions.

2)Keep these instructions.

3)Heed all warnings.

4)Follow all instructions.

5)Do not use this apparatus near water.

6)Clean only with dry cloth.

7)Do not block any ventilation openings.

Install in accordance with the manufacturer’s instructions.

8)Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat.

9)Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades with one wider than the other. A grounding-type plug has two blades and a third grounding prong. The wide blade or the third prong are provided for your safety. If the provided plug does not fit into your outlet, consult an electrician for

replacement of the obsolete outlet.

10)Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point where they exit from the apparatus.

11)Only use attachments/accessories specified by the manufacturer.

12)Use only with the cart, stand, tripod, bracket,

or table specified by the manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over.

13)Unplug this apparatus during lightning storms or when unused for long periods of time.

14)Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped.

The following mark and symbols are located on bottom of the unit.

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE SCREWS.

NO USER-SERVICEABLE PARTS INSIDE.

REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.

The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.

The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance.

The unit should be installed near an accessible AC power outlet, with the power cord connected directly to it.

To completely disconnect power from the unit, unplug the power cord from the AC power outlet.

VQT2H71

WARNING:

TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK OR PRODUCT DAMAGE,

DO NOT EXPOSE THIS APPARATUS TO RAIN, MOISTURE, DRIPPING OR SPLASHING AND THAT NO OBJECTS FILLED WITH LIQUIDS, SUCH AS VASES, SHALL BE PLACED ON THE APPARATUS.

USE ONLY THE RECOMMENDED ACCESSORIES.

DO NOT REMOVE THE COVER (OR BACK); THERE ARE NO USER SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.

CAUTION!

DO NOT INSTALL OR PLACE THIS UNIT IN A BOOKCASE, BUILT-IN CABINET OR IN ANOTHER CONFINED SPACE. ENSURE THE UNIT IS WELL VENTILATED. TO PREVENT RISK OF ELECTRIC SHOCK OR FIRE HAZARD DUE TO OVERHEATING, ENSURE THAT CURTAINS AND ANY OTHER MATERIALS DO NOT OBSTRUCT THE VENTILATION VENTS.

CAUTION!

THIS PRODUCT UTILIZES A LASER.

USE OF CONTROLS OR ADJUSTMENTS OR PERFORMANCE OF PROCEDURES OTHER THAN THOSE SPECIFIED HEREIN MAY RESULT IN HAZARDOUS RADIATION EXPOSURE.

DO NOT OPEN COVERS AND DO NOT REPAIR YOURSELF. REFER SERVICING TO QUALIFIED PERSONNEL.

(Bottom of product)

FCC Note:

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

Any unauthorized changes or modifications to this equipment would void the user’s authority to operate this device.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Responsible Party:

Panasonic Corporation of North America

One Panasonic Way Secaucus, NJ 07094

Support Contact:

Panasonic Consumer Electronics Company Telephone No.: 1-800-211-PANA (7262)

2

Image 2
Contents If you have any questions contact PANA7262 Warranty can be found onRegion management information Important Safety Instructions Bottom of productListening caution BatteriesAC adaptor For USA-California OnlyTable of contents AccessoriesUnit and media care Firmware updatesMaintenance Disc and card handlingUser recorded media Media Disc and card informationCommercially sold discs RR/rRW/rR DLSD cards Discs that cannot be played in this unitUnit Charge indicatorOverview Remote control transmitter Remote controlInsert the button-type battery included Range of useUsing the unit connected to the AC adaptor Adjusting the LCD screen anglePreparing the Power Supply Using the battery packChecking the remaining battery charge Connecting the included Car DC AdaptorDetaching the battery pack Press SUB Menu while the power is OnShowing Function Menu Easy SettingTurning on/off the unit Turn the unit off automaticallyDisc Adjusting the pictures on the LCD screenLoading the disc or SD card SD cardBasic play Playing video contents To return to the previous screen To switch from other menus to Avchd or MPEG2 menuChapter playback DVD-VR AvchdOther operations during play Changing audio Screen AspectStatus messages DVD-VR MPEG2Playing still pictures Useful functions during still picture playPress 3, 4 to select Zoom out and press OK Press 3, 4, 2, 1 to select Set and press OK RotateZoom out To select the still pictures in another folderInsert a disc To switch from other menus to MP3 menuPlaying music Press 3, 4 to select the track and press OKEnjoying Bonusview in BD-Video Signal TypeWhat is BONUSVIEW? Formatting SD cards/Deleting dataChanging settings with the on-screen menu On-screen menu operationsVideo PlayAudio Summary of settings Changing the unit’s settingsSetup menu operations Press 3, 4, 2, 1 to select the option and press OKOthers TV Aspect SettingDisplay ≥ Discs must conform to UDF File formatExtension Files must have the extension .mp3 or MP3 BD-RE/DVD-RAM Structure of folders that can be played in this unitDVD-R/DVD-R DL/CD-R/CD-RW SD cardScreen messages Indicators and screen messagesIndicators To reset this unit Troubleshooting guidePower Visit our website to find a service centerOperation Other difficulties with playback SoundCard Specifications Glossary Contact Information cdrequest@am-linux.jp Language code listLicenses As of November Limited WarrantyProduct or Part Name Parts Labor Model NumberIndex