Samsung HT-H6500WM user manual Network Setup, Configuring Your Network Connection, Wired Network

Settings

2)Set the Anynet+ (HDMI-CEC)feature to On in both the TV and the product.

3)Search for and then select the product in the TV's Anynet+ (HDMI-CEC)list. For more exact instructions, see the Anynet+ section of the TV's user's manual.

Support

Remote Management

When activated, lets Samsung Call Center agents diagnose and fix problems with the product remotely. Requires an active Internet connection. Remote Management service might not be available in some countries.

Software Update

For more information about the Software Update function, see "Upgrading Software" on page 24.

Use Mode

Lets you set the Use Mode. If you are using the home theater at home, always select Home Use. Store Demo is for retail display settings only.

Contact Samsung

Provides contact information for assistance with your product.

Reset

Reverts all settings to their defaults except for the network and Smart Hub settings. Requires that you enter your security PIN. Press and hold the 123 button until the Num pad appears on the screen. When the Num pad appears, select a number using the ,. button and then press the OK button. The default security PIN is 0000.

Network Setup

When you connect this product to a network, you can use network based applications and functions such as Smart Hub and BD-LIVE, and upgrade the product's software through the network connection. For more information about accessing and using Internet services, see the Network Services chapter of this manual on pages 41~48. Instructions for configuring the network connection start below.

Configuring Your Network Connection

If you didn't configure your network connection during the initial settings procedure or you need to reset the network connection, follow the directions below.

Before you begin, contact your Internet Service Provider to find out if your IP address is static or dynamic. If it is dynamic, and you have a wired or wireless network, we recommend using the Automatic configuration procedures described below.

If you are connecting to a wired network, connect the product to your router using a LAN cable before you start the configuration procedure.

To begin configuring your network connection, follow these steps:

1.In the Home screen, select Settings, and then press the OK button.

2.Select Network, and then press the OK button.

3.Select Network Settings, and then press the OK button.

4.Go to the instructions for Wired networks starting below or the instructions for Wireless networks starting on page 21.

Wired Network

ĞĞWired – Automatic

After following Steps 1 to 3 above:

1.In the Network Settings screen, change Network type to Wired. Then, select Connect and press the OK button. The product detects the wired connection, verifies the network connection, and then connects to the network.

2.When it is done, highlight OK, and then press OK button.

20 - English