Sharp BD-HP80U operation manual Troubleshooting Network, Other, To Reset this Player

Troubleshooting

Network

Problem		Possible causes and solutions
Cannot connect to the Internet.	When the wired Internet connection is made
	•	Is the LAN cable connected properly?
	•	Is the wrong cable such as a modular cable used? Connect a LAN cable to the
		ETHERNET terminal. (Page 20)
	•	Is the power for the connected equipment, such as a broadband router or modem
		turned on?
	•	Is the broadband router and/or modem properly connected?
	•	Is the proper value(s) set in the network setting? Check “Communication Setup”.
		(Pages 43–45)

When the wireless Internet connection is made

•Is the power for the connected equipment, such as a wireless router or access point turned on?

•Is the wireless router or access point properly connected?

•Are there any obstacles, such as physical structures (brick and concrete walls, etc.) and electronics (microwave, etc.) between the wireless router/access point and the player? As this may cause interference with the wireless signal, make sure to keep obstacles away.

•Is the proper value(s) set in the network setting? Check “Communication Setup”. (Pages 43–45)

Cannot download BD-LIVE contents. • Make sure that this player is connected to the Internet.

•Is the USB memory device properly connected? Check that the USB memory device is connected to the USB terminal of this Player.

•Check if the BD disc supports BD-LIVE.

•Check the setting for “BD Internet Access”. (Page 42)

Other

Problem		Possible causes and solutions
The TV operates incorrectly.	•	Some TVs with wireless remote control capability may operate incorrectly when
		using the remote control of this Player. Use such TVs away from this Player.
The Player heats up during use.	•	When using this Player, the console cabinet may heat up depending on the usage
		environment. This is not a malfunction.
POWER indicator will remain lit.	•	When the AC cord is removed from the outlet, the POWER indicator will remain lit
		for a short period. This is normal and is not a malfunction.
To Reset this Player		POWER indicator

•If this Player receives strong interference from a source such as excessive static electricity, strong external noise, malfunction of power supply, or voltage caused by lightning during use or a wrong operation is sent to the Player, errors like the Player not accepting an

operation may occur.

	Press and hold POWER on the Player until the POWER indicator disappears.
	POWER
•	When a reset is performed while the power is on, the Player will turn off. Turn the power on again. At this point, it may take
	a few moments for the system processing to finish before the Player is ready for use. During the system processing, the BD/
	DVD/CD mode indicator on the Player will blink. Once the system processing has finished, the indicator will finish blinking and
	then light up normally. You can operate the Player when the BD/DVD/CD mode indicator is lit.
•	Since all settings including the language setting stored in memory are also reset when a reset has been performed, they must
	be set again.
•	When the problem persists even after performing a reset, unplug the AC cord and plug it in again. If this does not solve the	Appendix
	problem, contact the nearest service center approved by SHARP.

iii