Sharp BD-HP20H Checking the setup sound, Press a/b/c/d to select the speaker, then press Enter

SETTINGS

5Press a/b/c/d to select the speaker, then press ENTER.

MENU [SPEAKER SETTINGS]

0dB			3.8m/0dB
SW		3.8m/0dB		C
				3.8m/0dB
		L
					R
	LS				RS
	2.0m/0dB				2.0m/0dB
		TEST START		FINISH

6Press c/d to select the preferred item, then press a/b to select the preferred setting, then press ENTER.

	MENU [SPEAKER SETTINGS]
	0dB			3.8m/0dB
	SW	3.8m/0dB			C
						3.8m/0dB
		L
						R
		LS				RS
		2.0m/0dB				2.0m/0dB
			SIZE	DISTANCE	LEVEL
					0dB
			LARGE	3.8 m
	Speakers				Selectable size
L/R			LARGE*, SMALL
C/RS/LS			LARGE*, SMALL, NONE
SW			YES*, NO

* Factory preset

LARGE: The cone diameter is 16 cm or larger.

SMALL: The cone diameter is smaller than 16 cm.

Selectable Distance	0.1m through 9.0m
range	(Settings available in 0.1m increments)
	The factory preset value: 3.8m(L/R/C)
	2.0m(RS/LS)
Selectable Output	-6dB through +6dB
Level range	(Settings available in 1dB increments)
	The factory preset value is 0dB.

7Repeat steps 5 and 6 until each speaker's size, distance, and level are set.

MENU [SPEAKER SETTINGS]

0dB		3.8m/0dB
SW			C
	3.8m/0dB		3.8m/0dB
	L			R
LS				RS
2.0m/0dB				2.0m/0dB
	TEST START		FINISH

NOTE

•The speakers L and R, LS and RS move relative to one another.

•The speakers L and R are automatically set to “LARGE” when the subwoofer SW is set to “NO”, even after speakers L and/or R are set to “SMALL”.

•The images of speakers set to “NONE” disappear or are greyed out on the screen.

•As for a subwoofer, there are no settings for distance.

Checking the setup sound

8Press a/b/c/d to select “TEST START”, then press ENTER.

MENU [SPEAKER SETTINGS]

0dB			3.8m/0dB
SW		3.8m/0dB		C
				3.8m/0dB
		L
					R
	LS				RS
	2.0m/0dB				2.0m/0dB
		TEST START		FINISH

•After switching to TEST mode, you can hear the Test sound from each speaker in turn.

•If you press a/b/c/d to select the preferred speaker while the TEST sound is present, you can hear the TEST sound of the speaker that you selected.

•If you press a/b/c/d to select “TEST TONE STOP” and press ENTER, you can stop the Test sound

40