Troubleshooting

Square noise (mosaic) appears on the screen.

•Blocks in images may be visible in scenes with rapid movement due to the characteristics of digital image compression technology.

Video stops.

•Has the Player been subjected to shock or impact? Are you using it in an unstable location? The Player will stop if it senses shock or vibration.

Left and right channels of audio are reversed, or sound comes out of only one side.

•Are left and right audio cables connected to the opposite terminal, or is one side disconnected?

Disc does not play back automatically.

•Have you set a disc that has an automatic playback function?

The Player heats up during use.

•When using this Player, the console cabinet may heat up depending on the usage environment. This is not a malfunction.

The Player makes a snapping sound when starting playback or loading a disc.

•The Player may sometimes make a snapping sound when starting playback if you have not operated it for a while or when loading a disc. This is the sound of the Player operating, and is not a malfunction.

Cannot operate the Player.

•Are you operating the Player within the speciﬁ ed operating temperature range? (Page 52)

STANDBY indicator will remain lit.

•When the AC cord is removed from the outlet, the STANDBY indicator will remain lit for a short period. This is normal and is not a malfunction.

NOTE

Reset

•If this Player receives strong interference from a source such as excessive static electricity, strong external noise, malfunction of power supply, or voltage caused by lightning during use or a wrong operation is sent to the Player, errors like the Player not

accepting an operation may occur. Press and hold B (POWER)

on the Player until “” appears on the front panel display when the Player does not operate properly even after the power has been turned off. Then, after the a (STANDBY) indicator is lit, turn on the power.

•When a reset is performed while the power is on, the Player will turn off. Turn the power on again. At this point, it may take a few moments for the system processing to ﬁ nish before the Player is ready for use. During the system processing, the BD and DVD/CD mode indicators on the front panel display of the Player will blink. Once the system processing has ﬁ nished, the indicators will ﬁ nish blinking and then light up normally. You can operate the Player when the BD and DVD/CD mode indicators are lit.

•Since all settings including the language setting stored in memory are also reset when a reset has been performed, they must be set again.

•When the problem persists even after performing a reset, unplug the AC cord and plug it in again. If this does not solve the problem, contact the nearest service centre approved by SHARP.

The following conditions do not always denote trouble. Therefore, perform the checks described below before calling for service. If the problem cannot be corrected by the use of this guide, remove the main plugs from the wall socket, and contact the dealer or supplier from whom the unit was purchased in order to obtain service. Where this is not possible

please visit our web-site www.sharp.co.uk/customersupport.

Customers without Internet access may telephone 08705 274277 during ofﬁ ce hours (or (01) 6760648 if telephoning from Ireland),

Certain replacement parts and accessories may be obtained from our main parts distributor, who can be contacted on the following numbers:

WILLOW VALE ELECTRONICS LTD.:

0121 766 5414

In the unlikely event of this equipment requiring repair during the guarantee period, you will need to provide proof of the date of purchase to the repairing company. Please keep your invoice or receipt, which is supplied at the time of purchase.