Grundig Troubleshooting Guide for CDS 7000 Blu-ray Player

INFORMATION------------------------------------------------------------------------------------------------------------------

Troubleshooting

Not every picture or sound problem is caused by a defect in your device. Cables that have accidentally been disconnected, damaged discs and flat batteries for the remote control will impair functioning.

If the following measures do not resolve the problem satisfactorily, please contact your specialist dealer.

To reset this unit

To return all settings other	Select Yes in Restore Default Settings in the Setup menu. This returns
than some settings to the	all values in the Setup menu and the on-screen menu, except for
factory preset.	parental setting to the default settings.

Power

No power.	Insert the AC power supply cord securely into a known active AC
	outlet.
The player switches to	This is a power saving feature.
	The Auto Power Down function is activated. Press »8« on the player
standby mode.
	to turn the device on.
Operation

	The batteries are depleted. Replace them with new ones.
	You are not pointing the remote control at the main unit’s remote con-
The remote control doesn’t	trol signal sensor during operation.
work properly.	Colored glass may obstruct the signal reception/transmission.
	Don’t place the signal sensor in direct sunlight or in areas that may be
	subject to sunlight exposure.
	Select the correct playback source (BD-ROM or Media).
	Some operations may be prohibited by the disc.
	Reset the device as follows:
The player is on but cannot	1. Press »8« on the device to switch the device to standby. If the de-
be operated.	vice doesn’t switch to standby, alternatively, disconnect the AC power
	supply cord, wait one minute, then reconnect it.
	2. Press »8« on the device to switch it on. If the device still cannot be
	operated, consult the dealer.
	Condensation has formed: Wait 1 to 2 hours for it to evaporate.
Play fails to start even when	Insert the disc correctly with the label facing up.
(PLAY) is pressed. Play	The disc is dirty.
starts but then stops imme-	You tried to play a blank disc or unplayable disc on this device.
diately.
Startup is slow. When the	Startup takes time in the following situations.
player is turned on, audio	Immediately after a power failure or the AC power supply cord is
and video output takes a	connected.
long time.	When the unit is connected with an HDMI cable.

ENGLISH 35­