Grundig GBP 7000 3D manual TV screen and video, Internet, Sound, English 37­

INFORMATION------------------------------------------------------------------------------------------------------------------

TV screen and video

	Make sure that the LED/LCD-TV is connected to the VIDEO OUT so-
The images from this player	cket or HDMI OUT socket on this device.
do not appear on the tele-	Make sure that the LED/LCD-TVs input setting (e.g., VIDEO 1) is correct.
vision.	The device is likely to enter screen saver status.
Picture is distorted.	Try to reset the device. To do so, press "8", wait for 5 seconds and
	then press this button again.
Video is not output in high-	High definition video cannot be output through the VIDEO OUT.
definition.	Confirm that the HDMI Resolution in the Setup menu is set properly.
The 4:3 aspect ratio picture	Use the LED/LCD-TV to change the aspect. Refer to your LED/LCD-TVs
expands left and right.	operating instructions.
	Insert a USB memory stick with a free space. Select BD-Live Storage
When it is playing BD-LIVE	from the BD-Live Menulist. Then restart the device.
	Please check the internet is available or not. Some of the disc need the
disc, Video output is a
	support of internet.
black screen.
	Please check the connection cable to the router. If it is loose, please
	insert again.

Internet

–WLAN network is deactivated, switch on the WLAN network. Desired WLAN network not – SSID is suppressed on the router; display SSID on the router.

found.– Distance to router is too large; reduce distance to router.

	– MAC adress of the device is not enabled on the router;
Connection to router not	enable MAC address on the router.
	– Data transfer from the router is encrypted; Enter the network key
established.
	(WEP orWPA) on the device.
	If this does not help, check the entire router configuration.

Sound

	Check the connections and the “Digital Output” settings. Check the
	input mode on the amplifier/receiver if you have connected one.
No sound. Low volume.	Press »AUDIO« to select the audio signal.
	The sound effects (Re-master, V. Surround, etc.) will not work when the
Distorted sound.
Cannot hear the desired	bitstream signal is output from the HDMI OUT socket or the
	»COAXIAL« socket.
audio type.
	When “BD-Video Secondary Audio” is set to “Off”, Dolby Digital
	Plus, and Dolby TrueHD are output from the »COAXIAL« terminal as
	Dolby Digital or DTS Digital Surround bitstream.
	Try to reset the device. To do so, press "8", wait for 5 seconds and
	then press this button again.
Cannot switch dubbed lan-	There are discs for which audio cannot be changed because of how
	the disc was created.
guage or the audio format .	When connecting an amplifier/receiver using a coaxial cable or an
	HDMI cable, you cannot switch the audio if “Digital Output” is set to
	“Bitstream”. Set “Digital Output” to “PCM” or connect using audio
	cables.
	ENGLISH 37­