Samsung SHR-3010 user manual Mode setup and cable connection, Interface

DIGITAL VIDEO RECORDER

GB GB

Caution

Please be sure to turn the system off before you replace or add the HDD. If not, the HDD may poorly operate or the life may be reduced.

Mode setup and cable connection	AT-Bus Interface Cable and Power Supply Cable are connected to AT-Bus Interface
	Connector are connected by referring to following drawing to ensure the HDD mounted on
Set a HDD mode and connect cables after mounting the HDD to product.	product can properly operate.
Below is shown drawing of Power Connector and AT-Bus Interface Connector and
Configuration Jumper Block of HDD.

					AT-Bus
					Interface
40-Pin AT-Bus	8-Pin Configuration		4-Pin DC		Connector
Interface Connector	Jumper Block	Power Connector
	Pin 1
Pin 1		4	3	2	1
					40Pin

	AT-Bus	40Pin
	Interface
		Header
Setting of HDD mode is performed in a Configuration Jumper Block.	Cable
When mounting two hard disk drives on the product, one should be set in the Master Mode
and the other in the Slave Mode. Basically, since the hard disk drive mounted on the product		Bevel
is in the Master Mode, when mounting a new hard disk drive it can be set in the Slave		DC Power
		Connector
Mode. For example, mode is set as follows in case of Samsung Spinpoint V40 HDD:
		Power Supply
		Cable
		(4Pin)
Master Mode	If successfully mounting the HDD on the product and then booting the system, the system
	recognizes that a new HDD is mounted and starts to operate after formatting the first HDD.
Slave Mode

Caution

We recommend Samsung Electronics’ Spinpoint V40 SV4002H or SV8004H as a HDD for this product. When installing an additional HDD, please be sure to inquire at the store where you purchased this product.

1-9 1-10