Environment Setup
1
Hardware
Press set up button for system setup
Screen which inputs password will be appeared. The screen will not be appeared if password is not created.
Hardware [Camera]
Description
Select Camera : To decided which camera to use
When Camera Button is pressed: Camera in use
When Camera Button is not pressed: Camera not in use
camera not in use’ is selected, it may lower the recording speed, so it is important to select camera which you will use only.
Name
:Input the name of place which the camera will be installed
Sensor
:Input the sensor number which will be used with each camera
1 up to 16 external sensors can be connected and if the external sensor activates then linked camera will record the image.
Input additional comma(,) in case several external sensors are to be linked together. For example) When operating external sensors number 2 and 3 and you wish to record the image of number 1 camera, then input ”2, 3” on Camera ”Sensor” Category.
P/T
:Check if the selected camera is PTZ.
In this case, PTZ related equipment should be connected and selected camera will indicate PAN/TILT on top of image.
P/T Type
:Model of
P/T ID
:Select ID from P/T connected to the system.
Baud Rate
:Baud rate might be different depending on the type of PAN/TILT camera. Currently 4800BPS, 9600BPS, 19200BPS and 38400BPS are supported.
Sensor Preset interworking
:When data is inputted into a sensor interworking with the corresponding camera, Sensor Preset Interworking feature will move the image preset in Pan/Tilt mode.
For more information about presetting the position for Pan/Tilt mode, see “Presetting” in “Pan/Tlit Mode” part.