Samsung SPR-7416 manual It might cause an explosion, It might cause fire or electric shock

Warning

Warning

Do not disassemble or repair the system by yourself since the system has high voltage part inside.

• It might cause fire, electric shock or hurt.

Locate the product in shade where proper temperature remains and avoid place next to hot object. Do not place the equipment or device in the place people visits a lot.

• It might cause fire.

Replace the battery with the product that the manufacturer appointed or the equal product. Dispose the battery according to the manufacturer’s instructions.

• It might cause an explosion.

If HDD is full, change the set-up to keep up with recording and check again if you allow the data to be erased.

(Refer to the “The record is not available” item in the fault report, the supplement.)

We do not bear the responsibility for the data corruption caused by the user’s lack of care.

The bottom surface must be moisture-free. And, be cautious about any possible delicate facters, such as ungrounded extension cable, abraded power cord, lack of safe grounding. When any problem occurs, please consult to an expert .

• It might cause fire or electric shock.

Position it in an open space with flat surface, and do not stand it on end or diagonally.

• If it falls down, it might cause hurt.

When properly connected to the HDD, the LED status indicator in front of the system blinks. Be sure that the LED status indicator blinks continuously.

If the life of the HDD which stores the data ends, video data to be stored can be damaged and unrecoverable. When the screen is broken while playing the data stored in HDD in the midst of recording, please request a service centeror the place you bought it to replace the HDD promptly.

We do not bear the responsibility for the data corruption caused by the user’s lack of care.

The cables of the power cable connectors, video signal input/output signal, Serial Port and LAN Cable connectors on the back of the system can be pressed down and damaged, if it is set up too close to the wall. Maintain the distance of 15 cm between back of the main body and the wall.

• It might cause fire, electric shock or hurt.

The fluctuation of operation voltage must be within 10% of the regulation voltage, and the electric outlet must be always ground. Insulation devices, such as, hair dryers, irons, refrigerators, etc., must not be co-used in the same outlet with this system is recommended for stable power supply.

•It might cause overheat, fire or electric shock.