Generic Pioneer Charter OCAP.fm Page 13 Friday, July 20, 2007 1:28 PM
NOTE: Use the following device code digits to control a specific device:
0 = Cable/STB
1 = TV
2 = DVD/VCR
3 = Audio
For example, to search for a code for your TV:
1.Turn on your TV.
2.On the remote control, press TV once; it blinks
once. Then press and hold SET UP until the TV key blinks twice.
3.Enter 9 9 1. The TV key blinks twice.
4.Press 1 (the device code digit for your TV).
The TV key blinks twice. Aim the remote control at the TV and press PWR once.
5.Press and release the CH+ key continuously, then stop when the TV turns off.
NOTE: In the search mode, the remote control sends IR codes from its library to the selected device, starting with the most popular code first.
6.Press PWR. The TV should turn on, then press SET UP to lock in the code.
NOTE: If the TV does not turn on during step 6, then 
slowly press and release CH- to go back through the codes, then press SET UP when the TV turns on.
7.To search for the codes of your other devices, repeat steps 1 through 5, but substitute the appropriate key (e.g., AUX, DVD, CBL, or STB) for the device you are searching for.
CHECKING THE CODES
If you have set up the C4000 and S4000 Remote Controls by searching for your device code (on the previous page), you may need to find out which
www.urcsupport.com
13