Generic Pioneer Charter OCAP.fm Page 21 Friday, July 20, 2007 1:28 PM
Restoring All Keymover Keys in a Single Mode
1.On the remote control, press CBL or STB once; it blinks once. Then press and hold SET UP
until the CBL key blinks twice.
2.Enter 9 9 4. The CBL (or STB) key blinks twice.
3.Press and release the mode key you want to
clear twice. For example, to clear all Keymover keys for the TV mode, press and release TV twice.
Restoring a Single Keymover Key
1.On the remote control, press the mode key once.
1.Press and hold SET UP until the
2.Enter 9 9 4. The mode key blinks twice.
3.Press and release the device key twice. For
example, to clear the CH+ key in TV mode, press and release CH+ twice.
CLEARING CUSTOM PROGRAMMING
The C4000 and S4000 Remote Controls contains a Custom Programming Reset program. You can use it to remove all custom programming, except your setup codes and reassigned device keys.
IMPORTANT: Executing this program erases all custom settings for Volume Lock, Learned Keys,
1.On the remote control, press and hold SET UP until the
2.Enter 9 8 0. The
blinks twice, pauses, and blinks twice again to confirm that all custom programming is cleared.
www.urcsupport.com
21