Programming TV/VCR Combo Control

Locate the brand name of your TV/VCR Combo in the Setup Codes For TV/VCR Combos section below, and write it in the following space.

TV/VCR Combo Brand: ________________________

The brands are listed in alphabetical order with popular codes listed first.You will use one of these codes to pro- gram the Millennium 3 to operate your TV/VCR Combo:

1.Turn on your TV/VCR Combo and insert a video cassette.

2. On the Millennium 3, press VCR once. Press and hold SETUP until the LED blinks twice, then release SETUP.

3.Enter the first four-digit code for your TV/VCR Combo. If you perform this procedure correct- ly, the LED will blink twice.

NOTE: If the LED did not blink twice after entering the code’s last digit, then repeat steps 2 through 3 and try entering the same code again.

4.Aim the Millennium 3 at your TV/VCR Combo and press VCR once. The unit should turn off. If it does not respond, repeat steps 2-3, trying each code listed for your brand until you find one that works. If it still does not work, try searching for the code (see Searching For Your Code on page 22).

5.If you’ve located a TV/VCR setup code that works your TV/VCR Combo and a separate TV code is also listed, you’ll need to program this code into the Millennium 3 to access vol- ume control (see Programming TV Control on page 8).

If there is no separate TV code listed, you will need to perform the following steps to access volume control:

a. Press and hold SETUP until the LED blinks twice, then release SETUP.

b. Enter 9 - 9 - 3. The LED will blink twice.

c. Press VCR once. The LED will blink twice.