PROGRAMMING CABLE CONVERTER (OR DBS RECEIVER) CONTROL
The Millennium 3 is preprogrammed at the factory to operate the cable converter given to you by your cable company. However, if you have another brand or model of cable converter or satellite receiver that you would like to control, then you’ll need to perform the following instructions to unlock the cable key, enter in a new code, and lock the cable key again.
To unlock the Cable key:
1.Turn on the Cable Converter or DBS Receiver.
2. 
On the Millennium 3, press CBL once. Press and hold SETUP until the LED blinks twice, then release SETUP.
3. 
Enter 9 - 9 - 7. The LED will blink twice.
4. 
Press CH – once. The LED will blink twice.
To program the Cable key:
1.Locate the brand name of your Cable Converter (or Direct Broadcast Satellite Receiver) in the Setup Codes For Cable Converters (or Setup Codes For DBS Receivers) section starting on the next page, and write it in the appropriate space.
Cable Converter Brand: ________________
or
DBS Receiver Brand: __________________
The brands are listed in alphabetical order with the most popular codes listed first.You will use one of these codes to reprogram the Millennium 3 to operate your Cable Converter or DBS Receiver.
2. 
On the Millennium 3, press CBL once. Press and hold SETUP until the LED blinks twice, then release SETUP.
3.Enter the first
NOTE: If the LED did not blink twice after entering the code’s last digit, then repeat steps 2 through 3 and try entering the same code again.
18