TROUBLESHOOTING
PROBLEM: | LED does not blink or blinks twice when you |
| press a key. |
SOLUTION: | Replace the batteries with two (2) new AA |
| alkaline batteries (see page 7). |
PROBLEM: | LED blinks when you press a key, but home |
| entertainment component does not respond. |
SOLUTION: Make sure you are aiming the Millennium 3 at | |
| your home entertainment component and that |
| you are within 15 feet of the component you are |
| trying to control. |
PROBLEM: | The Millennium 3 does not control home enter- |
| tainment components or commands are not per- |
| forming properly. |
SOLUTION: | Try all listed codes for the component brand |
| being set up. Make sure all components can be |
| operated with an infrared remote control. |
PROBLEM: | TV/VCR combo does not respond properly. |
SOLUTION: | Use the VCR codes for your brand. Some combo |
| units may require both a TV code and a VCR |
| code for full operation (see page 16). |
PROBLEM: | CH+ , CH |
| RCA TV. |
SOLUTION: | Due to RCA design |
| remote control will operate these functions. |
PROBLEM: | Changing channels does not work properly. |
SOLUTION: | If original remote control required pressing |
| ENTER to change channels, press ENTER on the |
| Millennium 3 after entering a channel number. |
PROBLEM: | Tried “Search Method”and still could not find a |
| working code. |
SOLUTION: | Try the “Search Method”again after clearing out |
| the device key as follows: Press and hold ENTER |
| until red light blinks twice, then release. Next |
| enter 9 - 9 - 2. Then press and release the device |
| key to be cleared twice. |
PROBLEM: | Remote control does not turn on Sony or Sharp |
| TV/VCR Combo. |
SOLUTION: | For power on, these products require program- |
| ming TV codes on the Millennium 3. For Sony, |
| use TV code 0000 and VCR code 0032. For Sharp, |
| use TV code 0093 and VCR code 0048. |
26