CHECKING THE CODES
If you have set up the Millennium 3 using the Searching For Your Code procedure, you may need to find out which
For example, to find out which code is operating your TV:
1.Turn on your TV.
2.
On the Millennium 3, press and hold SETUP until the LED blinks twice, then release SETUP.
3.
Enter 9 - 9 - 0. The LED will blink twice.
4. 
To view the code for the first digit, press 1 once. Wait 3 seconds and count the number of LED blinks (e.g., 3 blinks = 3) and write down the number in the leftmost TV Code box below.
NOTE: If a code digit is “0”, the LED will not blink.
5.Repeat step 4 three more times for remaining
digits. Use 2 for the second digit, 3 for the third digit, and 4 for the fourth digit. Finish writing down the code in the TV Code boxes below.
6.To check for the codes of other components, repeat steps 1 through 5, but substitute the appropriate key (i.e., VCR or CBL) for the (VCR or Cable) component you are checking.Write down the codes in the appropriate boxes below.
TV Code
VCR Code
CABLE Code
23