Pentair LX-100EZ owner manual Water Temperature Sensor

WATER TEMPERATURE SENSOR

For use with optional Indoor Control Panel only.

Select a convenient location to mount the Temperature Sensor (model TS-5L) in the plumbing system between the filter pump and the heater.

Drill a 5/16” diameter hole in the pipe, and insert the Sensor.

Use a screwdriver to open the hose clamp (included). Position clamp over the Sensor, and gently tighten around the pipe.

CAUTION

Overtightening of clamp can cause deformation of o-ring seal.

Run 2-conductor cable (25 ft. is included with Installation Hardware package) between Sensor location and low-voltage compartment of LX-100 RF Power/Load Center.

At the LX-100 RF Power/Load Center, strip insulation of both conductors ¼”, and connect to circuit board at SNS- and SNS+ Screw Terminals. Pay attention color-coding (green conductor connects to SNS-; red conductor connects to SNS+).

LX-100 RF POWER/LOAD CENTER

	REMOTE SWITCHES				SNS-	SNS+	1	2
FRZ	GND SPA AUX1 AUX2 AUX3	C	S	P
							+12
		GHTR

WATER TEMPERATURE

SENSOR

GRN

RED

Rev. F 3-26-04 17 P/N 520050