POSIFLEX Business Machines XP3000, XP3300 warranty Self Test, Paper Cutting, Printer setup

appropriate position of sensor block. The default height of near end sensor is the lowest position.

Self Test

For XP-3000/3300 series printer’s test mode, please turn off the terminal first. After the system power off, please press and hold down the feed button while turning on the system power switch. The printer will then perform a self-test mode. A sample slip of self-test result is printed as in the sample at right.

The header is printed in text mode and the rest part of this slip is printed in page mode. If FEED button pressed at this moment, a font table will be printed in text mode again. To exit the test printing, please turn the printer off and on again.

Paper Cutting

Generally, after paper printed and automatically cut every time, printer will retract the paper roll in order to reduce the paper loss (adjustable function, please see following chapter “Printer setup”).

The printer will leave the advance paper in 4.8 mm long for each print. It is highly suggested to print the logo and necessary paper feeding to make 4.8 mm paper advance right after each cut to prevent curling up and jamming of paper front edge inside the paper exit slot. Another important issue is please set every receipt length at least 6cm for every auto-cut model in order to let the receipt pass through the paper exit channel and easily to take. Please notice that if the receipt length is not enough 6cm, the printer will automatically push the paper to 6 cm.

Printer setup

There are two difference way to setup XP-3000/3300’s printer. Firstly, one is the DIP Switch inside of terminal for setup the function such as baud rate, Full-cut mode and others. Another switch is setup trough software to adjust not only the hardware switch function but also add printer density and others. Through software adjustment, the printer can set up the software setup is the

Page 9