Press the center button 
on the RZCPG to bring up the INCLUDE CNTRLLER screen, where you will be prompted to place the controller in program mode.
NOTE: Leviton Controllers require an inclusion process that differs
from Dimmers, Switches and Plug-
In Modules. Controllers must be placed into program mode before they can be included into the network
(refer to individual device instruction sheet). NOTE: If no controllers are in system, use down arrow button 
to skip to STEP 4.
Once your controller has been placed in program mode, press the center button 
on the RZCPG. The RZCPG will go through the communication process and assign the node information for that device. The TEXT EDITOR will display where you can name your device (refer to TEXT EDITOR pg. 6).
Once your name is displayed,
press the center button | .The | INCLUDE CNTRLLER | |
RZCPG will confirm inclusion | Node included! | ||
and prompt you to continue to | Node ID #3: | ||
Room Controller | |||
INCLUDE CONTROLLER by | |||
| |||
pressing the center button | or | More? Press | |
to continue to the Next step by pressing the right soft key 
NOTE: The confirmation process will take some time, specifically in large networks. Remain close to the controller until the confirmation is complete.
STEP 3 Update Controller
NOTE: The INSTALL CHECKLIST screen will appear with the selection box around STEP 3
-Update Controller when NEXT STEP is chosen from STEP 2.
Press the center button 
to bring up the UPDATE CNTRLS screen where a list of all the controllers in the network will be displayed. With the selection box around the first controller listed press the center button 
.
x1
INSTALL CHECKLIST
1.Include Dim/Swch
2.Include Controller
3.Update Controller
4.Create Areas
5.Set Associations
Back | Next Step |
x1
UPDATE CNTRLS
Room Controller
Hall Controller
Back (2) Who Is
7