Leviton Programmer/Remote manual Create Areas

Page 10

The RZCPG will prompt you to stand within 3 feet of that controller. Press the right soft key (YES) to update your controller. NOTE:

It is important that you remain within 3 ft. of the controller you've selected from the list. If you are unsure about which controller you are updating you can use the "Who Is" command (see pg. 13). Leviton controllers will blink during the update process, confirming you are updating the correct controller. Update only one controller at a time.

x1

UPDATE

Please stand within 3 ft from controller and press YES

to continue

NOYES

x1

UPDATE

Node Updated! Node ID #4 Room controller

Return

Once the RZCPG confirms UPDATE it will display the updated node information. Press left soft

key (Return). Continue this process until all of your controllers have been updated. Each time you successfully update your controller it will be removed from the list. Once all of your controllers have been updated, press the right soft key to continue to the NEXT STEP.

STEP 4 Create Areas

NOTE: The INSTALL CHECKLIST screen will appear with the selection box around STEP 4 - Create Areas when NEXT STEP is chosen from STEP 2.

Press the center button to bring up the AREA screen. With

<<NEW >> selected press the center button to bring up the CREATE AREA screen. You can now name your new area by pressing the center button (refer to TEXT EDITOR pg. 6). Once you name your new area, press the center button to save the information and return to the CREATE AREA screen.

x1

INSTALL CHECKLIST

1.Include Dim/Swch

2.Include Controller

3.Update Controller

4.Create Areas

5.Set Associations

Back Next Step

x1

AREA

<< NEW >>

Back Next Step

x1

CREATE AREA

Name: Area #1

Add Devices...

8

Cancel

Save

 

 

Image 10
Contents Programmer/Remote Table of Contents Introduction Programmer/RemoteButton LeftArrow Buttons DisplayEvent, etc ChartSingle brackets on By Installation StartupInstallation Checklist Include Dimmers/SwitchesInclude Controller Text EditorTo use the pre-made Templates Update Controller Include Controller byCreate Areas Step Associations when Next Step isSet Associations OFF buttonSecurity ON, 1 OFF, 2 ON, 2 OFF etcInstall Complete Device List Main Menu ScreenWHO is Area ProfileContrast SettingsBuzzer Advanced Settings? Battery LevelSystem Setup SecurityNetwork Rediscovery NetworkJoin as Secondary Controller inclusion This step will erase anyExisting data in the remote Replication processReplace Node Refer to Text EditorRTS Devices HAI SetupAssociation Device PropertiesWho Is Refer to WHO Is... pg.13 Version ResetUtilities Rediscovery PLPage Limited 5 Year Warranty and Exclusions Leviton Instruction SHEET/MANUAL