Installing the Keyspan Remote Software

Keyspan: Remote for iTunes - User Manual (Mac OS X & Windows)

Keyspan software is necessary for this setup.

Tech Note: How To Check Your Airport Express Firmware Version: Please note that you can check your Airport Express firmware version by using Apple's Airport Admin Utility. For details, please refer to your Airport Express documentation.

Before you begin installing the Keyspan Remote software (a note for previous

users of Keyspan Digital Remote software and hardware)...

If this a new installation of the Keyspan Remote for iTunes hardware AND software, please skip ahead to the Installing the Keyspan Remote Software subsection.

If you are upgrading from a previous version of Keyspan's Remote software (ie the Keyspan Digital Media Remote software for Mac or Windows), please note that the version 2.2 (and greater) Keyspan Remote Software installer makes various changes.

WINDOWS USERS:

On Windows, the Keyspan Remote Software version 2.2 (and greater) installer will update all applications, control panels, and master REM (KDMR17A, KDMR15A, JVC_VCR) and MAP (KDMR20-15, KDMR20-17) files to latest versions. It will will not update the KeyspanDMR17 MAP file or any custom made REM files.

MAC OS X USERS:

On Mac OS X, the Keyspan Remote Software version 2.2 (and greater) installer will detect if you have installed any previous versions of the Keyspan Digital Media Remote software. If it finds any previous Map and settings files that don't match the existing

2.2files, the installer will ask you if you'd like to perform a clean install. Click OK to perform a clean install and remove any changes made to your Map files and DMR software settings. Click Cancel to continue using your previous Map files and settings.

If you are using the 15 button remote (remote control model URM-15A) that was included in the original Keyspan Digital Media Remote package, please note that you will need to configure the Keyspan Remote Software's Map Editor to use your 15 button remote. To do this To tell the Map Editor to use your 15 button remote, you must:

1.Open the Keyspan Remote Software

2.Click the Configure/Open Map Editor button (this opens the Map Editor)

3.In the Map Editor, access the Settings menu (in the menu bar), file from the Remote command.

4.Close the Map Editor windows to save your changes

Installing the Keyspan Remote Software

NOTE: Installing the Keyspan Remote software is only

This User Manual applies to the Keyspan Remote for iTunes Software Version 2.3

Rev 2005jun01

Page 4