Regency FireGenie Setting the Program Mode, Programming the On-Time of Time Period

SETTING THE PROGRAM MODE

The user can program two On-Times and two Off-Times as well as the Temperature settings for each day of the week. The PROG button is used to initiate the programming mode. The “+” and “-” buttons are used to adjust the time and temperature settings.

Note: The Remote Control must be “ON” in order to set the Programs.

To change or re-program your Remote Control, confirm that the Remote Control is in program mode. “PROG” will be displayed on the LCD. Hold the “PROG” button down for 2 seconds, you will see “PROG” and the Time both flash. Continue through the set-up instructions.

Follow the steps below to set the programs:

1) Programming the On-Time of Time Period 1

Press and hold the PROG button for 2 seconds or more to initiate the Programming mode. The symbol “PROG 1” will flash to indicate the Remote is in Programming mode.

The On-Time for Time Period 1 will also flash. The “+” and “-” buttons can be used to adjust this time setting.

The LCD will show the current setting in Time Period 1 for Monday:

Programming of Time Period 1

Time Period 1 On-Time

10 FPI FireGenieTM Remote Control Manual