MATCHING REMOTE CONTROL & RECEIVER ID CODE
The Remote Control handset has a set of unique ID codes that is
To ensure the Remote Control is matched to the Receiver correctly, please follow the steps below;
1.Ensure that the pilot is lit and the pilot control knob is in the ON position at the appliance.
2.Ensure both the Remote Control and the Receiver box are switched OFF.
3.Install the 2 xAAA alkaline batteries into the Remote Control.
4.Install the 4 xAAalkaline batteries into the Remote Receiver.
5.Switch the Receiver box to the REMOTE position.
6.Press and hold the PROG and PRESET buttons simultaneously on the remote control for up to 20 seconds. During this time, the remote will display “LC” while it is transmitting codes to the receiver. Once it has successfully transmitted, the burner will come on. If it does not work the first time wait for 1 minute and repeat steps 1 - 5.
7.Release both the PROG and PRESET buttons. The remote control will revert back to normal, but the burner will still be on.
8.Press the ON/OFF button on the remote 2 times to turnn the burner off.
9.The remote control is now programmed to the receiver and the appliance can now be operated with it.
The control box will only learn the Remote ID codes during the first 30 seconds after power is applied and will ignore this special command from the Remote Control after the first 30 seconds.
NOTE: This must only be performed by a qualified installer.
4 | FPI FireGenieTM Remote Control Manual |