ADVANCED FUNCTION - PROGRAM MODE
Note: Ensure the Remote Control has been turned ON in order to operate in this mode.
Program mode is selected by pressing and releasing the AUTO/MAN button until the symbol “PROG” is shown on the LCD. The Remote Control will operate according to the settings in the 2 Time Periods programmed by the user. Refer to Setting the Program Mode for details.
The Remote Control has been
Time Period |
|
| Set Temperature (°F) |
|
|
|
|
1 – Mon. – Fri. | 6:00 am | 8:00 am | 71.5 |
|
|
|
|
1 – Sat. – Sun. | 7:00 am | 10:00 am | 71.5 |
2 – Mon. – Fri. | 5:00 pm | 10:00 pm | 71.5 |
|
|
|
|
2 – Sat. – Sun. | 4:00 pm | 11:00 pm | 71.5 |
By pressing and holding the PRESET button for 10 seconds or longer, the Remote Control’s programs will be reset to the above default factory set program.
Pressing and releasing the PROG button successively will allow the user to review the programmed times for each day of the week.
To exit this mode wait approximately 20 seconds after the last button is released or press the ON/OFF button twice to return to the last operating mode.
If the Time Periods have not been programmed in the Remote Control, the display will show the following:
Programs have not been set.
FPI FireGenieTM Remote Control Manual | 9 |