Knoll Systems 1080p DLP user manual Removing and Installing the Lamp Unit

Page 58

Removing and Installing the Lamp Unit

Follow these instructions to replace the lamp.

•Be sure to remove the lamp unit by the handle. Be sure not to touch the glass surface of the lamp unit or the inside of the projector.

•To avoid injuring yourself and damage to the lamp, be sure to carefully follow the steps below.

•Do not loosen other screws except for the lamp unit cover and lamp unit.

(Only the silver screws are loosened).

1.If the projector is running, press on the projector or on the remote control to turn off the power. Wait until the cooling fan stops.

	ENTER
	STATUS
EXIT	MENU
ECO	INPUT

Appendix

INPUT 1

INPUT 2

Warning!

Do not remove the lamp unit from the projector right after use. The lamp will be very hot and may cause burn or injury.

2.Disconnect the power cord and wait at least an hour for the lamp to cool.

3.Remove the lamp unit cover.

•Loosen the user service screw that secures the lamp unit cover. Then open the cover in the direction of the arrow.

M4* 8.9 screws

57

Image 58

Contents 1080p DLP Front Projector Preface EnglishPreface Product Disposal Contents Appendix Introduction Package Contents Features Temperature indicator ComponentsUsing the Kensington Lock Projector Rear ViewRemote Control Using the Remote Control Connections and Setup Connecting the Power Cord Connecting the Projector to Other DevicesBefore Setting Up Computer usingConnecting to Video Equipment Connecting to Video EquipmentTo the projector Connecting to Component Video EquipmentConnect an Hdmi to Hdmi cable Connect the above cable toConnecting the Projector to a Computer Connecting to a ComputerConnecting the Thumbscrew Cables Plug and Play FunctionUsing the Adjustment Feet Adjusting the Lens Using the Lens ShiftStandard Setup Front Projection Setting up the ScreenAn Example of Standard Setup When using a normal screen When using a wide screenScreen Size and Projection Distance Short throw lens Screen Size and Projection Distance Long throw lens Projection from behind the screen Projection using a mirrorCeiling-mount setup Projecting a Reversed/Inverted ImageBasic Operation Basic OperationOutlet Basic ProcedureImage Projection PressAbout the Input modes Select the Input modePress on the projector to InfoPress Or X to select Language Selecting the On-screen Display LanguagePress Menu Language, and then pressBasic Menu Bar ItemsOperation This list shows the items that can be set in the projectorUsing the Menu Screen Menu Selections AdjustmentsAdjusting the Picture Adjusting Image PreferencesSharpness Black Level Advance Adjusting Computer Images Component / PC onlyEasy to Use Functions Selecting the Picture Display Mode Select layoutVideo Computer Overscan Adjust Overscan TypePosition Function Keystone Function Selecting the Economy Mode Setting the Power SaveAutomatic Power OFF Function Sync ThresholdSource Select OSD Time OutFilm Mode OSD BlendingSTI Noise Reduction Blank ScreenSetting the PRJ Mode ResetReversing/Inverting Projected Images Lamp Timer Reset StatusFactory Reset Input SourceAppendix Maintenance Cleaning the projectorCleaning the Ventilative Holes Cleaning Ventilative HolesAbout the Lamp Replacing the LampTemperature LED Over Temperature Removing and Installing the Lamp Unit Follow these instructions to replace the lampRemove the lamp unit Connect the power cordReset the lamp timer Insert the new lamp unitConnecting Pin Assignments Pin No. Signal Name ReferenceComputer Compatibility Chart ComputerVideo Compatibility Chart IR Remote Key Discrete CodesTroubleshooting INPUT1 ComponentAppendix Product Specifications DescriptionShort Throw Lens Dimension Units mm inchLong Throw Lens Dimension Unit mm inchRelease Version a