Knoll Systems 1080p DLP Remove the lamp unit, Insert the new lamp unit, Connect the power cord

Page 59

4. Remove the lamp unit.

•Loosen the securing screws from the lamp unit. Hold the lamp unit by the handle and pull it in the direction of the arrow.

5. Insert the new lamp unit.

•Press the lamp unit firmly into the lamp unit compartment. Fasten the securing screws.

•Attach the lamp unit cover.

•Close the lamp unit cover in the direction of the arrow (to the close mark) on the side of the projector. Then tighten the user service screw.

Info

•If the lamp unit and lamp cover are not correctly installed, the power will not turn on, even if the power cord is connected to the projector.

Resetting the Lamp Timer

Reset the lamp timer after replacing the lamp.

1. Connect the power cord.

•Plug the power cord into the AC socket of the

projector.

2. Reset the lamp timer.

• Select the “Lamp Timer Reset” from the “Options”

menu from the menu screen. Press . Select “OK” to reset the timer or “Cancel” to abort. (See page 50)

•“LAMP 0H” is displayed, indicating that the lamp timer is reset.

	Info
	Make sure to reset the lamp timer only when replacing
	the lamp. If you reset the lamp timer and continue to	Appendix
	use the same lamp, this may cause the lamp to become
	damaged or explode.
	damaged or explode.

58

Image 59

Contents 1080p DLP Front Projector English PrefacePreface Product Disposal Contents Appendix Introduction Package Contents Features Components Temperature indicatorProjector Rear View Using the Kensington LockRemote Control Using the Remote Control Connections and Setup Computer using Connecting the Projector to Other DevicesBefore Setting Up Connecting the Power CordConnecting to Video Equipment Connecting to Video EquipmentConnect the above cable to Connecting to Component Video EquipmentConnect an Hdmi to Hdmi cable To the projectorConnecting to a Computer Connecting the Projector to a ComputerPlug and Play Function Connecting the Thumbscrew CablesUsing the Adjustment Feet Using the Lens Shift Adjusting the LensAn Example of Standard Setup Setting up the ScreenStandard Setup Front Projection Screen Size and Projection Distance Short throw lens When using a wide screenWhen using a normal screen Screen Size and Projection Distance Long throw lens Projecting a Reversed/Inverted Image Projection using a mirrorCeiling-mount setup Projection from behind the screenBasic Operation Basic OperationPress Basic ProcedureImage Projection OutletInfo Select the Input modePress on the projector to About the Input modesLanguage, and then press Selecting the On-screen Display LanguagePress Menu Press Or X to select LanguageThis list shows the items that can be set in the projector Menu Bar ItemsOperation BasicMenu Selections Adjustments Using the Menu ScreenAdjusting Image Preferences Adjusting the PictureSharpness Black Level Advance Component / PC only Adjusting Computer ImagesEasy to Use Functions Select layout Selecting the Picture Display ModeVideo Computer Overscan Type Overscan AdjustPosition Function Keystone Function Setting the Power Save Selecting the Economy ModeSync Threshold Automatic Power OFF FunctionOSD Time Out Source SelectOSD Blending Film ModeSTI Blank Screen Noise ReductionReversing/Inverting Projected Images ResetSetting the PRJ Mode Status Lamp Timer ResetInput Source Factory ResetAppendix Cleaning the projector MaintenanceCleaning Ventilative Holes Cleaning the Ventilative HolesReplacing the Lamp About the LampTemperature LED Over Temperature Follow these instructions to replace the lamp Removing and Installing the Lamp UnitInsert the new lamp unit Connect the power cordReset the lamp timer Remove the lamp unitPin No. Signal Name Reference Connecting Pin AssignmentsComputer Computer Compatibility ChartIR Remote Key Discrete Codes Video Compatibility ChartINPUT1 Component TroubleshootingAppendix Description Product SpecificationsUnits mm inch Short Throw Lens DimensionUnit mm inch Long Throw Lens DimensionRelease Version a