USING THE REMOTE TO CONTROL VCR FUNCTIONS
Operating the precoded function for your VCR.
This remote is designed to operate different types of VCRs. You must first program the remote to match the remote system of your VCR. (Refer to page 30.)
1.Set the
2.Turn ON your VCR.
3.Aim the remote control at the front of your VCR.
4.Hold down the PROG button on the remote, enter the two digit preset code that matches your VCR as shown on page 30. The remote will turn off your VCR when the correct two digit preset code is entered. When this occurs, the remote control is pro- grammed for your VCR. If the VCR does not turn off after five seconds, try a different two digit preset code.
5.The remote will now control your VCR.
NOTES:
1.If your VCR cannot be operated after performing the above procedures, your VCR’s code has not been precoded into the remote.
2.In the unlikely event that your VCR cannot be operated after performing the above procedures, please consult your VCR operating guide.
3.The remote control will remember the codes you have programmed until the batteries are removed from the remote control. After replacing the batteries repeat the entire programming procedure as stated above.
4.If your VCR does not have a power function, the remote will issue the CHANNEL UP function.
5.The MENU button will act as the VCR MENU button for HITACHI VCRs.
6.The
7.The SLEEP button will act as your VCR ‘100’ button if required.
8.The REC button must be pressed two times to begin VCR recording. This button will also act as the VCR record button when the remote is in CABLE or SAT mode.
POWER
RECSTOP PAUSE
SLOW | PROG. | TV/VCR |
TV/CABLE/SAT
VCR
VOLMUTE CH
INFO | EXIT |
| GUIDE |
| L |
| I |
| G |
| H |
RECALL | C.S. T |
FAV | MENU | FAV |
CH |
| CH |
SVCS SCHED
REC | SELECT |
PRECODED VCR buttons
These buttons transmit the chosen precoded VCR codes.
EXCLUSIVE TV buttons
These buttons are for operating the TV.
1 2 3
4 5 6
7 8 9
INPUTSLEEP
0
27