Hitachi 50UX57B 60UX57B manual Picture Cautions, Operation of Your Television

Page 4

SAFETY TIPS

PROTECTION AND LOCATION OF YOUR TELEVISION

16-1. If an outside antenna is connected to the television, be sure the antenna system is grounded so as to provide some protection against voltage surges and built-up static charges. Section 810 of the National Electrical Code, NFPA No. 70-1975, provides information with respect to proper grounding of the mast and supporting structure, grounding of the lead-in wire to an antenna discharge unit, size of grounding conductors, location of antenna discharge unit

connection to grounding electrode, and requirements for the grounding electrode.

16-2. Note to CATV system installer: (Only for television with CATV reception). This reminder is provided to call the CATV system installer’s attention to Article 820- 40 of the NEC that provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as practical.

￿￿￿￿￿￿￿

￿￿￿￿￿￿￿

￿￿￿￿

￿￿￿￿￿￿

￿￿￿￿￿

￿￿￿￿￿￿￿

￿￿￿￿￿￿￿￿￿￿￿￿￿￿

￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿

￿￿￿￿￿￿￿￿

￿￿￿￿￿￿￿

￿￿￿￿￿￿￿￿￿

￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿

￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿

￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿

￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿

￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿

￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿

￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿

EXAMPLE OF ANTENNA GROUNDING AS PER NATIONAL ELECTRICAL CODE INSTRUCTIONS.

17.An outside antenna system should not be located in the vicinity of overhead power lines or other electrical lights or power circuits, or where it can fall into such power lines or circuits. When installing an outside antenna system, extreme care should be taken to keep from touching such power lines or circuits as contact with them might be fatal.

18.For added protection for the television during a lightning storm, or when it is unused for long periods of time, unplug it from the wall outlet and disconnect antenna. This will prevent damage due to lightning and power-line surges.

OPERATION OF YOUR TELEVISION

19.This television should be operat- ed only from the type of power source indicated on the marking label. If you are not sure of the type of power supply at your home, consult your dealer or local power company. For televisions designed to operate from battery power, refer to the operating instructions.

20.If the television does not operate normally by following the operating instructions, unplug the television

￿￿￿from the wall outlet and refer

￿￿￿￿￿￿

servicing to

qualified

service

￿￿￿￿￿￿￿

personnel.

Adjust only

those

 

controls that are covered in the instructions as improper adjustment of other controls may result in damage and will often require extensive work by a qualified service technician to restore the television to normal operation.

21.If your television is to remain unused for a period of time, (such as when going on a holiday), turn

￿the television OFF and unplug it from the wall outlet.

IF THE TELEVISION DOES NOT OPERATE PROPERLY

22. If you

are unable to restore

 

23. Whenever the television is

normal

operation by

following

 

damaged or fails, or if there is a

the detailed procedure

in

your

￿￿￿￿￿￿￿

distinct change in performance

operating instructions,

do

not

 

that indicates a need for service,

attempt any further adjustments.

 

unplug the television and have it

Unplug the television and call

 

checked by a qualified service

your dealer or service technician.

 

technician.

24.It is normal for some televisions to make occasional snapping or popping sounds, particularly when being turned on or off. If the snapping or popping is continuous or frequent, unplug the set and consult your dealer or service technician.

￿￿￿￿

￿￿￿

￿￿￿￿￿￿￿

FOR SERVICING AND MODIFICATION

25.Do not use attachments not recommended by the television manufacturer as they may cause hazards.

26.If replacement parts are required, be sure the service technician has used replacement parts specified by the manufacturer that have the same characteristics as the original part. Unauthorized substitutions may result in fire, electric shock, or other hazards.

27.Upon completion of any service or repairs to the television, ask the service technician to perform routine safety checks to determine that the television is in safe operating condition.

￿￿￿

￿￿￿

PICTURE CAUTIONS

Picture Burn Prevention

Continuous on-screen displays such as video games, stock market quotations, computer generated graphics, and other fixed (non-moving) patterns can cause permanent damage to projection television receivers. Such “PATTERN BURNS” constitute misuse and are NOT COVERED by your HITACHI Factory Warranty.

When using Picture-in-Picture function, the sub-picture should not be left permanently in one corner of the screen or a “PATTERN BURN” may develop over a long period of time.

Public Viewing of Copyrighted Material

Public viewing of programs broadcast by TV stations and cable companies, as well as programs from other sources, may require prior authorization from the broadcaster or owner of the video program material.

4

Image 4
Contents ON-SCREEN Display Useful Information IndexPower Source Important Safeguards Safety TipsPicture Cautions Operation of Your TelevisionAccessories Remote Control Battery Installation and ReplacementHOW to SET UP Your NEW Hitachi Projection TV AntennaLocation ViewingHOOK-UP Cables and Connectors Antenna Connections to Rear Jack PanelFront Panel Controls Power light Remote Control sensorAI Artificial Intelligence sensor Magic FocusFront Panel Jacks and Connections Rear Panel Jacks Way signal splitter Rear Panel ConnectionsTips on Rear Panel Connections Connecting External Audio Amplifier External ConnectionsConnecting a Monaural Audio VCR or Laserdisc Player Connecting External Video SourcesBefore Operating External Video Source Connecting a Stereo VCR or Stereo Laserdisc Player Optional, see tips onConnecting a Stereo Laserdisc Player or DVD Player to Input Audio System Setup Genius Remote Control CLU-615MP MULTI-PAGE select switchMULTI-PAGE buttons Light buttonSwitch MULTI-PAGE WindowsHOW to USE the Genius Remote to Control Your TV TV buttonCable button SAT buttonVOLUME, Mute buttons PICTURE-IN-PICTURE buttonsPIP CH button Help buttonHOW to USE the Remote to Control Your TV PICTURE-IN-PICTURE PIP Single Mode PIPPIP button Swap button PICTURE-IN-PICTURE Surf Mode PIPMove button Freeze FRZ button With PIP on Freeze FRZ button With PIP OFFSingle Freeze Strobe FreezeUsing the Remote to Control VCR Functions Operating the precoded function for your VCRPrecoded VCR buttons Exclusive TV buttonsPrecoded Cable BOX buttons Using the Remote to Control Cable BOX/SATELLITE FunctionsPrecoded Satellite BOX buttons Operating the precoded function for your audio equipment Using the Remote to Control Audio Equipment FunctionsPrecoded AMP, CD, or Tape buttons AUDIO, CABLE/SATELLITE, and VCR Codes Amplifier Brand CodeUltratec OSD Audio SET UP Menu LanguagePlug & Play Signal Source Reception BandAuto Channel SET Channel Memory Channel List R S O R Clock SETMagic Focus Channel ID CustomVideo ID Family Favorites Menu Family Favorites Operation Child Lock Child LockEvent Prog Auto Link Closed Caption DisplayMode ChannelHitachi First Time TourReset VideoContrast Brightness Color Tint SharpnessAdvanced Settings Color TemperatureUltra AI Artificial Intelligence Auto ColorAudio Bass Treble BalanceMTS Mode Auto Noise CancelPerfect Volume Internal SpeakersTheater Theater ModesSRS Main TV Audio Wireless SoundPIP Audio Info Special Event ReminderCalendar Auto Help Care of Your Hitachi Projection TV Your Remote Control Do notReception Problems Ignition NoiseSymptoms Useful InfoOutputs Inputs50UX57B 60UX57B Hitachi Home Electronics DivisionQR41081